检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]中南大学冶金科学与工程学院,长沙410083
出 处:《有色金属(冶炼部分)》2012年第8期11-13,共3页Nonferrous Metals(Extractive Metallurgy)
摘 要:以镍转炉渣还原硫化熔炼得到的钴冰镍为原料,在常压下于硫酸体系中进行浸出,考察了硫酸浓度、液固比、浸出时间及浸出温度对钴冰镍中有价成分浸出率的影响。结果表明,液固比和硫酸浓度对钴、镍、铁的浸出率影响较大。当硫酸浓度为1.6mol/L、液固比5、浸出时间2.5h、浸出温度85℃时,铁浸出率达到69%,镍、钴浸出率分别控制在1%和5%以内,取得了很好的选择性浸出效果。The cobalt-nickel matte, a reduction product from nickel converter slag by vulcanization smel-ting, was atmospherically pressure leached at the sulfuric acid system. The effects of sulfuric acid concen- tration, ratio of liquid to solid (L/S), leaching time and temperature on leaching rate of valuable metals were investigated. The results show that L/S and sulfuric acid concentration have great influence on the leaching rate of cobalt, nickel and ferrum. The ferrum leaching rate reaches to 69%, nickel and cobalt leaching rate could be controlled below 1% and 5 % respectively under the conditions including sulfuric acid concentration of 1.6 mol/L, L/S of 5, leaching time of 2.5 h, and leaching temperature of 85 ℃. A good selectivity leaching effect was obtained.
分 类 号:TF803.2[冶金工程—有色金属冶金]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117