检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:张磊[1,2] 赵凤兰[2] 侯吉瑞 张建忠 徐宏明[1,2] 李程辉
机构地区:[1]中国石油大学(北京)石油工程学院 [2]中国石油大学提高采收率研究院,北京102100
出 处:《科学技术与工程》2012年第22期5593-5596,共4页Science Technology and Engineering
基 金:国家科技重大专项(2009ZX05009)资助
摘 要:通过对长庆油田地层压力相近的一千多口采油井的调查分析,得出了四个物性参数中孔隙度对压裂效果最为敏感,其次是渗透率,再次为储层厚度,含油饱和度为最不敏感的因素。而在实际油藏中由于孔隙度与渗透率的变化范围较小,储层有效厚度的变化范围很大,使得在实际压裂选井选层过程中要综合考虑储层厚度、渗透率、孔隙度、含油饱和度之间的数量关系,该关系可以通过灰色关联法确定。对长庆油田某一区块7口井的压裂实际表明,以储层物性对压裂效果的影响分析为基础的灰色关联评价法能较好地符合油田实际压裂结果。Physical parameters were directly related Based on the investigation and analysis of more than one to fracturing effect of the ultra low permeability reservoir. thousand production wells that the formation pressure were similar in Changqing oilfield, the conclusion was that porosity was the most sensitive factor to fracturing effect, the next was permeability, reservoir effective thickness, and the most insensitive factor was oil saturation. In the actual reservoir, the variation scope of porosity and permeability was small, but the reservoir effective thickness was big, so the quantitative relation of reservoir thickness, permeability, porosity and oil saturation should be comprehen- sively considered in the actual fracturing process of well and layer selection. And the quantitative relation can be determined by grey correlation method. The actual fracturing construction of seven wells in a block of Changqing oilfield show that grey correlation evaluation method can better meet the actual oil field fracturing on the basis of the reservoir physical properties on fracturing effect.
关 键 词:压裂失效 有效厚度 渗透率 孔隙度 含油饱和度 灰色关联评价
分 类 号:TE343[石油与天然气工程—油气田开发工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28