检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
出 处:《工程设计学报》2012年第4期294-297,共4页Chinese Journal of Engineering Design
基 金:国家自然科学基金面上项目(51075047)
摘 要:为了探求WN齿轮传动的强度机理和失效原因,依据WN齿轮负载传动时齿面的三维几何接触特征和弹性变形理论建立了接触强度分析模型,提出了基于WN齿轮啮合特征的接触强度分析方法.根据啮合过程中齿面接触载荷、啮合齿轮副和接触点数的变化,利用有限元分析进行了各种状况下的齿面接触应力计算,明确了WN齿轮接触强度设计中的螺旋角、中心距误差、齿宽及重合度对最大接触应力的影响结果.研究发现,当中心距和重合度及螺旋角等变化时,WN齿轮与渐开线齿轮呈现出了完全不同的载荷特征和强度机理.In order to discuss strength mechanism and failure causes of WN(Wildhaber-Novikov) gear transmission, the analysis model of contact strength in loading transmission was established based on three dimensional geometric contact feature and elastic deform of meshing tooth face. The study presented a method on the contact strength analysis of WN gear based on meshing feature. The tooth face contact stress of WN gear with various situations was calculated by FEM analysis and based on changing of contacting load, meshing points and gear pairs. The affectation result relations between the maximum contact stress and effects of helix angle, center distance error, face width and overlap ratio were carried out on the strength design of this gear. It is discovered that the loading feature and strength mechanism of WN gears and involute gears are completely different when the center distance and overlap ratio and helix angle were changed.
分 类 号:TH132.416[机械工程—机械制造及自动化] TH114
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.179