检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]辽宁工程技术大学力学与工程学院,阜新123000
出 处:《世界科技研究与发展》2012年第4期651-654,共4页World Sci-Tech R&D
基 金:国家自然科学基金面上项目(10972096)资助
摘 要:采用理论分析不同应力场下巷道轴线与最大水平主应力方向夹角的最佳角度,利用数值模拟不同夹角情况下,巷道围岩应力分布、正前方应力分布及变形特征。得出:1)最大水平主应力σ_H>最小水平主应力σ_h>垂直主应力σ_v时,最佳角度为0°;σ_v>σ_H>σ_h时,最佳角度为90°;σ_H>σ_v>σ_h时,最佳夹角为α_0。2)巷道开挖后,水平应力在两帮出现应力降低区,在顶、底板出现应力集中区;垂直应力在两帮出现应力集中区,在顶、底板出现应力降低区;随角度变化,应力变化区均有明显变化,正前方断面的最大主应力变化明显。3)巷道达到最佳角度时,围岩变形相对较小,最大主应力围绕在巷道周边,呈环状或类环状分布;其它角度时,围岩变形相对较大,最大主应力逐渐向顶、底板的四角或两帮发展。Theoretical analysis on the best angle between field tunnel axis and the direction of maximum horizontal principal stress, and the stress distribution in surrounding rock, in front of the stress distribution and deformation based on numerical simulation from different angle are given. It is obtained that : 1 ) When Maximum horizontal principal stress σH 〉 Minimum horizontal principal stress σh 〉 Vertical principal stress σt ,the best angle is 0 degrees;when σH 〉 σt 〉 σh ,the best angle α0 ;when σt 〉 σH 〉 σh ,the best angle is 90 degrees. 2) After the laneway have been dug,the horizontal stress will decrease in its two sides and increase at its top and bottom. The condition of the vertical stress is on the contrary. The stress clearly changes with the change of angle in all of the changing area, and the maximal-chief stress changes clearly in the forward cross section. 3 ) When tunnels have the best angle, rock deformation would be relatively small and the maximum principal stress would be around the tunnel periphery. When the tunnels don't have the best angle, rock deformation would be relatively large and the maximum principal stress would have a tendency to develop towards the four corners of the tunnel, or towards both the two faces.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.166