Ti-5Al-5Mo-5V-1Cr-1Fe合金的高温塑性变形行为  

Plastic deformation behavior of Ti-5Al-5Mo-5V-1Cr-1Fe alloy at high temperature

作　　者：李超[1] 张晓泳[1,2] 唐仁波[3] 周科朝[1] 

机构地区：[1]中南大学粉末冶金国家重点实验室,长沙410083 [2]中南大学冶金科学与工程学院,长沙410083 [3]湖南金天钛业科技有限公司,常德410007

出　　处：《中国有色金属学报》2012年第7期1914-1920,共7页The Chinese Journal of Nonferrous Metals

基　　金：国家自然科学基金委员会创新研究群体科学基金资助项目(51021063);湖南省科技重大专项资助项目(2010F51004);中南大学前沿研究计划资助项目(2009QZZD007);中南大学2009年博士后基金资助项目

摘　　要：在Gleeble-1500热模拟机上对Ti-5Al-5Mo-5V-1Cr-1Fe合金进行高温热压缩实验,研究该合金在变形温度为750~900℃、应变速率为0.001~1 s 1条件下的流变应力行为。利用光学显微镜分析合金在不同变形条件下的组织演化规律。结果表明：合金的流变应力随着应变速率的增大和变形温度的降低而增大;流变应力随着应变的增加而增大,出现峰值后逐渐趋于平稳;变形过程中的流变应力可用Arrhenius双曲正弦本构关系来描述,平均变形激活能为454.2 kJ/mol;各种变形条件均可细化原始晶粒尺寸。随着温度的升高和应变速率的降低,合金的主要软化机制由动态回复逐渐变为动态再结晶;在（α＋β）相区变形（750~850℃）时,α相对β晶粒的动态再结晶的发生起到阻碍作用。The hot deformation behaviors of Ti-5Al-5Mo-5V-1Cr-1Fe alloy were studied by a Gleeble-1500 machine at 750-900 ℃ with the strain rate of 0.001-1 s-1.The microstructural evolution of the alloy was investigated by optical microscopy.The results indicate that the flow stress of the alloy increases with increasing strain rate and decreasing deformation temperature.The flow stress increases with increasing strain until the stress reaches the peak value,then the flow stress remains constant.The flow stress in deformation can be described by Arrhenius hyperbolic sine constitutive equation,and the average activation energy is 454.2 kJ/mol.The original grain size can be refined under all deformation conditions.The main softening mechanism is changed from dynamic recovery to dynamic recrystallization with increasing the deformation temperature and decreasing the strain rate.In the（α＋β） region（750-850 ℃）,α phase can inhibit the dynamic recrystallization of β grains particles during deformation.

关 键 词：Ti-5Al-5Mo-5V-1Cr-1Fe合金 热变形 流变应力 显微组织 

分 类 号：I462[文学—其他各国文学]