液化天然气罐用9%Ni钢板坯连铸工艺优化  

Optimization of Slab Concasting Process of 9%Ni Steel for Liquefied Natural Gas Tank

作　　者：李建民[1] 陈远清[2] 刘东风[1] 仇圣桃[2] 吴夜明[2] 

机构地区：[1]太原不锈钢股份有限公司技术中心,太原030003 [2]钢铁研究总院连铸技术国家工程研究中心,北京100081

出　　处：《特殊钢》2012年第5期29-31,共3页Special Steel

摘　　要：分析了9%Ni钢(/%:≤0.10C、≤0.35Si、0.30～0.80Mn、≤0.005S、≤0.008P、8.5～10.0Ni、≤0.10Mo、≤0.10Al)200～220 mm板坯连铸试生产中出现的结晶器液面结壳、铸坯表面网裂纹产生原因,对连铸工艺进行优化。结果表明,液相线温度偏差是导致9%Ni钢液面结壳的主要原因,基于差示扫描量热法(DSC)的实测数据建立了新的液相线温度计算公式,得出试验的9%Ni钢的液相线温度,在钢水过热度为10～30℃时能较好地满足板坯的连铸要求。通过控制[N]≤25×10^(-6),[Al]≤0.03%,二冷比水量由0.6L/kg降至0.4L/kg,使9%Ni钢连铸顺行,铸坯内部和表面质量良好。The formation causes of occurred shell at meniscus in mold and network crack of slab surface in pilot con-casting production of 200 - 220 mm slab of 9% Ni steel （/% ： ≤0. 10C, ≤0. 35Si, 0. 30 - 0. 80Mn, ≤0. 005S, ≤ 0. 008P, 8.5 - 10. 0Ni, ≤0. 10Mo, ≤0. 10Al） are analyzed, and the optimization on concasting process has been carried out. Results show that the calculated deviation of liquidus temperature of 9% Ni steel is the main cause led to the shell oc-curred at meniscus, and based on experimental data by differential scanning calorimetry （ DSC）, a new liquidus tempera-ture calculation formula is established to get the liquidus temperature of tested 9% Ni steel, and as the overheat extent of liquid is 10 -30 ℃, it is available to meet the requirement of slab concasting. With controlling [ N] ≤ 25 x 10^-6, [ Al] ≤0. 03% and decreasing secondary cooling water rate from 0. 6 L/kg to 0. 4 L/kg the concasting of 9% Ni steel is going on smoothly, the inner and surface quality of slab is nice.

关 键 词：9%NI钢 板坯 连铸 液面结壳 网状裂纹 工艺优化 

分 类 号：TF777.1[冶金工程—钢铁冶金]