丁基橡胶装置聚合单元物料冷却工艺的改进模拟研究  

Simulation for material cooling process of butyl rubber polymeric unit

作　　者：闵晓兵[1] 范永将[1] 

机构地区：[1]中国石油兰州石化公司研究院,甘肃兰州730060

出　　处：《石化技术与应用》2012年第5期443-446,共4页Petrochemical Technology & Application

摘　　要：基于俄罗斯3万t/a溶液法丁基橡胶(IIR)聚合工艺,以液化天然气(LNG)释放冷能冷却乙烯来替代原有的制冷负荷,采用Aspen plus 11.1软件对提供冷量的流程进行了改进模拟。结果表明,以LNG作冷剂,可满足冷却物料和去除反应热的制冷所需负荷3 436 kW;改进后的冷却方式压缩功耗为1 545.7 kW,与原流程相比节省了2 346.3 kW,效率提高60.3%。Based on the Russia solution polymeri- zation process of 30 kt/a butyl rubber unit,the cool- ing medium ethylene was refrigerated by the cold en- ergy released from liquefied natural gas （LNG） to replace the original compression refrigeration load, and the software Aspen plus 11.1 was used to simu- late the improved refrigeration process. The results showed that LNG could supply enough cold energy of 3 436 kW for cooling materials and removing reaction heat,and the compression power consumption for the improved refrigeration mode were 1 545.7 kW, saving 2 346.3 kW power, and the compression efficien- cy increased by 60.3% compared with original process.

关 键 词：丁基橡胶 液化天然气 ASPEN PLUS软件 制冷 冷负荷 模拟计算 压缩效率 

分 类 号：TQ333.6[化学工程—橡胶工业] TQ018