检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:唐炬[1] 裘吟君 曾福平[1] 袁静帆 张晓星[1]
机构地区:[1]重庆大学输配电装备及系统安全与新技术国家重点实验室,重庆400044 [2]海南电力公司,海口570100
出 处:《电工技术学报》2012年第10期13-19,共7页Transactions of China Electrotechnical Society
基 金:国家重点基础研究发展计划(973计划)(2009CB724506);优秀博士论文基金(200749)资助项目
摘 要:H2O是影响SF6在局部放电下形成最终分解组分、组分含量及其产气速率等的重要因素之一,其影响机理及规律尚不完全清楚。本文利用研制的SF6局部放电分解试验平台,对不同H2O含量下SF6气体进行了48h局部放电分解试验,利用气相色谱检测得到了不同H2O含量的SF6在PD作用下所生成的各特征组分含量,并最终得到H2O对分解特性的影响规律。研究发现:H2O含量的增加会抑制CF4的生成,CO2的生成量高于CF4,对SO2F2和SOF2的生成均有先促进后抑制的作用,且对SOF2的促进和抑制作用都强于SO2F2;当H2O含量较低时,随局部放电时间延长,SO2F2与SOF2的浓度比即(SO2F2)/(SOF2)逐渐减小,当H2O含量较高时,随局部放电时间的增加该比值逐渐增加。因此,利用SF6放电分解特征组分来诊断设备故障时必须考虑H2O的影响。Among the influence factors of SF6 decomposition under partial(PD) discharge,H2O is the most significant one which affects its decomposed components,component concentration as well as the rate of gas generating.However,the influence regularity and the mechanism are still unclear recently.In this paper,SF6 decomposition testing apparatus is exploited and the experiment to simulate the influence of different H2O on the SF6 decomposition under PD is conducted in 48 hours.Gas chromatograph technology is used to detecting the content of the decomposed components and the influence regularity of H2O on SF6 characteristic decomposed components under PD is finally obtained.The study indicates that the increase of the H2O content will inhibit the generation of CF4 and CO2 while CO2 concentration is higher than CF4;H2O will promote both the generation of SO2F2 and SOF2 firstly and inhibit them afterwards,yet the promoting effect and inhibition effect on SOF2 is much stronger than SOF2.Besides,when H2O content is in low condition,the concentration ratio of SO2F2 and SOF2((SO2F2)/(SOF2))will gradually decrease along with the increasing time of partial discharge;when H2O is relative high,the concentration ratio will gradually increase instead.Thus,H2O must be taken into consideration while using characteristic decomposed components of SF6 to diagnose electrical equipment fault.
分 类 号:TM835[电气工程—高电压与绝缘技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117