基于Proteus的温控报警器设计  

Design of temperature control alarm system based on Proteus

作　　者：宋东亚[1] 黄家福[1] 

机构地区：[1]郑州华信学院,河南郑州451150

出　　处：《电子设计工程》2012年第23期93-95,共3页Electronic Design Engineering

摘　　要：利用仿Proteus真软件实现了基于AT89C51单片机的温控报警器仿真设计。详细分析温控报警器的硬件设计原理,并在Keil开发环境下设计了对应的驱动程序,在Proteus中完成了软、硬件的联合仿真调试,最后给出了仿真运行结果。通过Proteus软件和Keil软件的联合调试,大大缩短了开发周期,降低开发成本。该设计的电路及驱动程序对相应的实际应用系统具有一定的借鉴作用。The design of temperature control alarm system based on AT89C51 microcontroller was realized with an embedded system simulation software Proteus. A detailed analysis of temperature control alarm hardware design principle, and in the Keil development environment to design the corresponding driver, in the Proteus completed the soft, hardware co simulation debugging, finally gives the simulation results of operation. By using Proteus software and Keil software joint debugging, greatly reducing the development cycle, reduce development cost. The design of the circuit and the driver of the corresponding practical application system has a certain reference

关 键 词：PROTEUS KEIL 温控报警器 仿真 程序 

分 类 号：TN02[电子电信—物理电子学]