汽车后灯壳翘曲分析与模具反变形技术研究  

Technology of Reverse Deformation and Warpage Analysis of Rear Automotive Lamp Shell

作　　者：涂恒强[1] 辛勇[1] 

机构地区：[1]南昌大学机电工程学院,江西南昌330031

出　　处：《中国塑料》2012年第12期81-86,共6页China Plastics

基　　金：江西省自然科学基金资助项目(2012BAB206014);江西省科技支撑计划资助项目(20122BBE500044)

摘　　要：基于CAE模流分析技术,对汽车后灯壳进行了注射成型模流分析的数值仿真计算,并对后灯壳进行了现场跟踪测量。结果表明,得出的后灯壳翘曲残余变形仿真计算结果与测量值基本吻合,误差在50%以内。结合所制定的反变形方案,在这个仿真模型的基础上,对后灯壳注射成型时的反变形量进行了数值仿真优化,与无反变形量的注射成型相比,最优方案可使翘曲变形量减少90%以上。反变形技术可为注射成型时翘曲变形的控制、模具及工艺设计的选择和预留变形量的确定等提供可靠依据。Based on the CAE mold flow analysis techniques, a numerical simulation of injection molding analysis and a on-site tracking measurement were carried out on the rear automotive lamp shell. It was concluded that the simulation results of residual warpage deformation were basically consistent with the measured values with errors less than 50 %. On the basic of the numerical simulation model, combined with the scheme of reverse deformation, the optimum analysis of the reverse deformation was conducted with numerical simulation model, an optimum scheme was obtained. Compared with the injection without reverse deformation, the optimum scheme could reduce the warpage deformation about 90%. The technology of reverse deformation provided reliable theoretical references for the warpage controlling of injection molding, the choices of mold and process design, and the determination of the pre-set deformation.

关 键 词：汽车后灯壳 模流分析 翘曲分析 反变形 

分 类 号：TQ320.662[化学工程—合成树脂塑料工业]