检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李赛毅[1,2] 文浩[1] 雷力明[3,4] 张慧儒[1,5]
机构地区:[1]中南大学材料科学与工程学院,长沙410083 [2]中南大学有色金属材料科学与工程教育部重点实验室,长沙410012 [3]中航商用航空发动机有限责任公司,上海200241 [4]北京航空材料研究院钛合金研究室,北京100095 [5]华南理工大学机械工程学院,广州510640
出 处:《中国有色金属学报》2012年第11期3022-3028,共7页The Chinese Journal of Nonferrous Metals
基 金:国家重点基础研究发展计划资助项目(2007CB613803)
摘 要:采用金相、扫描电镜和电子背散射衍射(EBSD)研究两相区退火温度和时间对热压缩态TC11(Ti-6.5Al-3.5Mo-1.5Zr-0.3Si)双相钛合金组织和微观取向的影响。结果表明:初始魏氏组织在850℃热压缩后被破坏,形成较为细小、扭折的片层组织,晶粒取向呈非均匀分布;在后续700和900℃退火过程中,α相变形组织和亚结构发生静态再结晶而转变为等轴状晶粒,晶粒尺寸较退火前的更为细小,再结晶程度和等轴组织比例随保温时间的延长而增加,片层组织的球化程度、晶粒取向和形貌的均匀性与合金的再结晶程度相关。在900℃退火时,α相的再结晶程度较700℃退火时的更为明显;经过120 min退火后,合金发生完全再结晶,得到较为均匀、细小的等轴状组织。The effects of annealing temperature and time on the microstructure and microtexture of TC11(Ti-6.5Al-3.5Mo-1.5Zr-0.3Si) titanium alloy pre-deformed by hot working were investigated using optical microscopy, scanning electron microscopy and electron back-scattered diffraction(EBSD).The results show that the initial Widmanstatten structure is destroyed after hot compression at 850 °C,leading to fine and distorted lamellar structures with non-uniform grain orientation distributions.Upon subsequent annealing at 700 and 900 ℃,the deformed and substructured α phase evolve into refined equiaxed grains due to static recrystallization,while the extent of recrystallization and the proportion of equiaxed grains increase with the annealing time increasing.The globularization of lamellar structures and the heterogeneity of grain morphology and orientations depend on the extent of recrystallization. Compared with that of 700 ℃,annealing at 900 ℃ leads to more extensive recrystallization,and a reasonably homogeneous fully recrystallized microstructure with equiaxed fine grains is achieved after 120 min.
分 类 号:TG146.4[一般工业技术—材料科学与工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.33