改性热塑性酚醛树脂的制备及残炭率的影响因素  

Preparation of modified thermoplastic phenol-formaldehyde resin and influence factors of residual carbon

作　　者：阮胜军[1] 左小华[1] 张世磊[1] 廖庆玲[2] 

机构地区：[1]湖北理工学院化学与材料工程学院,湖北黄石435003 [2]武汉长江工商学院,湖北武汉430071

出　　处：《中国胶粘剂》2012年第12期33-36,共4页China Adhesives

基　　金：湖北省科技厅科研基金项目(2009CDZ003);湖北省教育厅基金项目(Q20104403)

摘　　要：在苯酚和甲醛原料中加入一定量的SiO2粉体改性剂,可成功制备出改性热塑性PF(酚醛树脂)。以热塑性PF的残炭率为考核指标,采用单因素试验法优选出制备硅改性PF的最优方案。结果表明,当m(苯酚)∶m(甲醛)=(1.30～1.36)∶1时,硅改性PF的残炭率较高且变化不大;当w(SiO2粉体)=0.9%、反应温度为90℃和反应时间为3 h时,改性热塑性PF的残炭率相对较高;此时,Si元素已均匀分布在PF基体树脂上,掺杂的SiO2有助于提高热塑性PF的耐热性能。A modified thermoplastic PF（phenol-formaldehyde resin） was successfully prepared when a certain content of SiO2 powder modifier was introduced into phenol/formaldehyde raw materials. Then,with residual carbon of thermoplastic PF as evaluation index,the optimal project of preparing silicon modified PF was preferred by single factor experiment. The results showed that the residual carbon for silicon modified PF was higher,and its change was little when mass ratio of re（phenol）：re（formaldehyde） was （1.30-1.36）：1. The modified thermoplastic PF had the relatively higher residual carbon when mass fraction of SiO2 powder was 0.9%,reaction temperature and reaction time were 90 ℃ and 3 h respectively. Meanwhile,the Si element was uniformly distributed in PF matrix resin, and the doped SiO2 was favorable for improving thermal stability of thermoplastic PF.

关 键 词：热塑性 酚醛树脂 SiO2粉体 残炭率 

分 类 号：TQ323.1[化学工程—合成树脂塑料工业]