检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
出 处:《现代机械》2012年第6期5-8,共4页Modern Machinery
基 金:江苏省高等学校大学生实践创新训练计划(JSS1137);南京农业大学SRT计划(1135A08)
摘 要:为了研究超声电解复合加工难加工材料上小孔工艺,在8 mm厚的不锈钢1Cr18Ni9Ti上进行通孔加工试验。通过正交试验研究了电压、初始间隙、阴极转速和进给速度对小孔直径和表面粗糙度的影响,运用综合平衡法得出最优组合是:电压7 V、初始间隙0.2 mm、阴极转速1 600 r/min、进给速度1.6 mm/min。In order to research the ultrasonic electrochemical compound machining holes on difficult-to-cut material, through-hole machining experiments were carried out on 8ram thick 1Crl8Ni9Ti stainless steel. Through orthogonal experiments, the influences of the voltage, the initial gap, the cathode speed of rotation and the feed rate on the holes diameter and surface roughness were studied. The optimum combination obtained by the consolidated balance method is as the following: the voltage 7 V, the initial gap 0. 2 mm, the cathode speed 1 600 r/min, the feed rate 1.6 mm/min.
关 键 词:超声旋转加工 电解加工 复合加工 小孔 正交试验
分 类 号:TG662[金属学及工艺—金属切削加工及机床]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.90