检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]清华大学化学工程系,化学工程联合国家重点实验室,北京100084
出 处:《化工学报》2013年第2期574-580,共7页CIESC Journal
基 金:国家自然科学基金项目(20976096);中国石油科技创新基金研究项目(2011D-5006-0407)~~
摘 要:用富含胺基的物质对多孔材料进行修饰可以得到高CO2吸附量的吸附剂。采用浸渍法将聚乙烯亚胺(PEI)和2-氨基-2-甲基-1-丙醇(AMP)负载在拟薄水铝石上,考察了CO2压力、胺类物质负载量等对吸附性能的影响。采用低温N2吸附/脱附法(BET)、扫描电镜(SEM)、傅里叶变换红外线光谱分析仪(FTIR)等手段表征了吸附剂的结构特征及其物理性质,并使用重量法微天平实验装置对吸附剂的性能进行了评价。实验结果表明,当温度恒定为50℃,压力小于1MPa时,负载PEI的吸附剂最高的CO2吸附量为77.53mg CO2.(g吸附剂)-1,最佳负载量为85%;压力大于1 MPa时,负载PEI的吸附剂最高的CO2吸附量为123.79 mgCO2.(g吸附剂)-1,最佳负载量为10%。负载AMP的吸附剂最高的CO2吸附量为128.01mg CO2.(g吸附剂)-1,最佳负载量为85%。CO2吸附稳定性实验表明,吸附剂对CO2的吸附性能稳定。Porous materials modified by amino can reach high CO2 adsorption capacity. In this study, adsorbents were prepared by modifying polyethylene imine (PEI) and 2-amino-2-methyl-1-propanol (AMP) on pseudoboehmite. The effects of CO2 pressure and content of PEI/AMP on CO2 capacity were examined. Adsorbents were characterized by N2 adsorption/desorption, scanning electron microscopy, and Fourier transform infrared spectroscopy. Experiment showed that at 50℃, the highest CO2 adsorption capacity reached 77.53 mg CO2· (g adsorbent) 1 with PEI loading of 85% at reaction pressures〈1 MPa. For reaction pressures 1 MPa〈P≤2 MPa, the highest CO2 adsorption capacity of 123.79 mg CO2· (g adsorbent) 1 was obtained. For AMP loaded adsorbents, the highest CO2 adsorption capacity was 128.01 mg CO2· (g adsorbent)^-1 with AMP loading of 85%. Adsorption/desorption cycles showed that CO2 capacity of adsorbents changed little.
关 键 词:吸附 二氧化碳 聚乙烯亚胺 2-氨基-2-甲基-1-丙醇 拟薄水铝石
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222