检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]辽宁工程技术大学矿业学院,辽宁阜新123000
出 处:《水利水运工程学报》2013年第1期71-75,共5页Hydro-Science and Engineering
摘 要:为了研究粗砂浆体水平管道流动水力坡度预测问题,通过分析和计算颗粒运动受力平衡关系,提出添加修正系数来修正干涉力的研究方法,并采用若干专家学者的试验数据,拟合出了修正系数的表达式.在此基础上,利用等效阻力模型,给出了粗砂水平管道流动水力坡度的计算模型,并借助相关学者的试验数据对该模型进行了检验.结果表明,模型计算值与实测值的偏差均小于10%,且考虑修正系数后,水力坡度的计算值相对增大,更加接近实测值.说明粗砂颗粒浆体管道中颗粒干涉力需要修正,且由此提出的粗砂颗粒水力坡度模型对于研究粗砂浆体管道输送技术具有一定参考价值.In order to study the predication of hydraulic gradient for coarse sand slurry in the horizontal pipe, based on the analysis and calculation of the coarse sand particle's balance relationship in the horizontal pipe, by adopting a research method of adding a correction factor L before interference force is put forward, and by using related experts' experimental data and through data fitting, an expression of correction coefficient L is given out. Based on this, by using an efficient resistant model, a hydraulic gradient calculation model for coarse sand slurry in the horizontal pipe is developed. The calculation model is verified by related experts' experimental data and it is found out that the deviation between the calculated values by author's model and the measured values is not more than 10%, and that after considering the correction factor L, the model-calculated values will relatively increase and move closer to the measured values. So in the coarse sand slurry pipeline, the interference force acting on coarse particles needs to be revised by correction factor, thus the hydraulic gradient calculation model put forward for coarse sand slurry can give a certain reference to the study of the transport of coarse sand slurry in pipes.
分 类 号:TV142[水利工程—水力学及河流动力学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.145.82.96