Fe/AC催化过氧化氢降解双酚A  

Catalytic wet oxidation of bisphenol A with hydrogen peroxide over Fe/AC catalyst

作　　者：周文[1] 程治良[1] 全学军[1] 陈波[1] 

机构地区：[1]重庆理工大学化学化工学院,重庆400054

出　　处：《化工学报》2013年第3期936-942,共7页CIESC Journal

基　　金：重庆市节能减排科技'接力'行动科技专项(CSTC2010AA7060)

摘　　要：传统Fenton反应存在对液相pH要求较高、Fe3+回收困难以及难以重复使用等问题。基于'活性离子固载化,酸性环境局部化'的设计思路,通过对活性炭(AC)表面酸化改性,制备得到载铁活性炭(Fe/AC)催化剂。研究了Fe/AC制备工艺与其性能之间的关系,结果表明,在载Fe3+量44.05mg.g-1、煅烧温度200℃的制备工艺下可得到催化活性较高、稳定性好的Fe/AC催化剂。用性能优良的Fe/AC催化H2O2降解双酚A(BPA),其较佳催化反应条件为:反应时间60min、反应温度20℃、溶液pH值为4.0≤pH≤8.0、Fe3+/H2O2摩尔比为0.007～0.012、30%H2O2用量为0.04ml H2O2.(mg BPA)-1。本工作制备得到的Fe/AC催化剂具有较好的重复使用性能,在实际废水处理领域具有较大的应用前景。There are some problems in the traditional Fenton process, such as narrower range of pH, and the difficulties to recovery Fe3＋ and to reuse it. Based on the design idea of“immobilizing active ions and localizing acidic environment”, Fe/AC catalysts were prepared by acidifying surface of activated carbon and then loading Fe3＋ on the modified AC, to study the relationship between Fe/AC catalyst performance and preparation parameters. The results show that Fe/AC catalyst with higher activity and stability are prepared at the conditions of Fe3＋ loading amount 44.05 mg · g-1 and calcination temperature 200℃. The degradation of bisphenol A （BPA）, an environmental hormone （endocrine-disrupting chemical）, was conducted using the Fe/AC catalyst prepared at these optimum conditions, and the results show that the optimal conditions for degradation of BPA are as follows： reaction time 60 min, temperature 20℃, pH 4.0 to 8.0, Fe3＋/H202 molar ratio 0. 007--0. 012, and 30% H202 dosage 0.04 ml · （mg BPA）-1. The Fe/AC catalyst prepared exhibits excellent performance for reutilization, showing greater prospect for application in treating wastewater.

关 键 词：载铁活性炭 类Fenton催化 内分泌干扰物 双酚A 

分 类 号：X5[环境科学与工程—环境工程]