背光源导光板散射网点形状的研究  

Study on Dot Shape for the Light Guide Plate of Backlight

作　　者：陈俄振[1] 郭震宁[1] 智佳军[1] 李建功[1] 胡治伟[1] 曾海[1] 

机构地区：[1]华侨大学信息科学与工程学院,福建厦门361021

出　　处：《激光与光电子学进展》2013年第3期161-166,共6页Laser & Optoelectronics Progress

基　　金：厦门市科技计划重点项目(3502Z20093033);泉州市科技计划重点项目(2008G7);福建省科技计划重点项目(2009H0034);福建省自然科学基金(2010j01338)资助课题

摘　　要：根据LED的光强分布推导出侧光式背光源导光板平面上某点的照度公式,并得出导光板中散射网点的排布公式。主要通过对导光板散射网点形状的研究,找出最适合导光板的网点形状。以半球形网点形状为基础,根据在两个方向上耦合进导光板的光线经半球形网点反射后恰好输出的条件,得出顶角在90°～132.2°的圆锥体网点为最佳的形状。最后在达到一定的输出光通量均匀性的情况下,经过光学软件TracePro模拟仿真,比较不同顶角值圆锥体网点导光板的总输出光通量。实验结果与理论结果相一致。According to the light distribution of LED, we figure out the formula of a dot illuminance on the plane of the edge-lighting backlight light guide plate （LGP）, and an arrangement formula of scattering dots in the LGP as well. The main purpose of this paper is, by studying the shape of the scattering dots in the LGP, to find out the scattering dots shape which is the most suitable for the LGP. Based on the hemispherical dots shape, according to principle that the light coupled into the LGP in two directions is reflected by the hemispherical scattering dots and just outputs from the LGP, it is obtained that the optimum shape of scattering netted dots is the cone whose apex angle between 90° and 132.2°. Under the condition of a certain uniformity of output light flux, by means of TracePro software simulation, the total output light flux is compared for the LGP with different apex angles of cone scattering dots. The experimental and theoretical results match well with each other.

关 键 词：光学设计 背光源 LED 导光板 网点排布 网点形状 

分 类 号：TB21[一般工业技术—工程设计测绘]