大型储罐抗风圈与加强圈设计计算  

Design and calculation for wind girder and stiffening ring of large-scale oil tank

作　　者：李玉坤[1] 孙文红[1] 梁军会 

机构地区：[1]中国石油大学(华东)工程力学系,山东青岛266555 [2]中油管道投产运行公司,河北廊坊065001

出　　处：《油气储运》2013年第2期125-130,共6页Oil & Gas Storage and Transportation

基　　金：中国石油大学(华东)自主创新科研计划项目"大型储罐浮顶结构优化设计研究";10CX04031A

摘　　要：储罐的大型化给抗风圈、加强圈设计提出了新的要求。在比较目前国内外大型储罐抗风圈、加强圈设计标准的基础上,以某20×104m3浮顶储罐抗风圈、加强圈的设计为例,分别根据中国标准GB50341和美国标准API650设计了其截面模量。运用ANSYS软件建立了其在不同荷载工况下的有限元数值计算模型,对抗风圈、加强圈分别进行了强度和稳定性计算,给出了罐壁的变形特点及极限风压值。对比分析根据GB50341和API650设计的抗风圈、加强圈的计算结果,给出了抗风圈、加强圈的设计计算建议,可为大型储罐的设计提供参考依据。(表1,图8,参12)Large-scale oil tanks propose new requirements for design of wind girder and stiffening ring. Under the premise of comparison between domestic and foreign design standards for the wind girder and stiffening ring of large storage tanks, modulus of section for the wind girder and stiffening ring of a 20 ~ 104m3 floating roof tank was designed respectively according to Chinese Standard GB 50341 and American Standard API 650. A finite element numerical calculation under different load conditions was built using large finite element software ANSYS to conduct strength and stability calculations respectively for the wind girder and stiffening ring so as to obtain deformation characteristics of the tank wall and extreme wind pressure value. Comparative analysis on calculation results of the wind girder and stiffening ring designed according to GB 50341 and API 650 was conducted to propose suggestions on design calculations of the wind girder and stiffening ring, which could provide useful references for designers of large storage tanks. （I Table, 8 Figures,12 References）

关 键 词：浮顶储罐 抗风圈 加强圈 有限元 稳定性 极限风压 

分 类 号：TE821[石油与天然气工程—油气储运工程]