Si含量对Mg-5Sn-1.5Al-1.2Zn合金组织性能的影响  

Influence of Si Content on Microstructure and Properties of Mg-5Sn-1.5Al-1.2Zn Magnesium Alloy

作　　者：张建新[1,2] 郭宇[3] 郭学锋[1] 

机构地区：[1]河南理工大学材料科学与工程学院,河南焦作454000 [2]河南理工大学文法学院,河南焦作454000 [3]河南理工大学电气工程与自动化学院,河南焦作454000

出　　处：《铸造》2013年第3期235-238,共4页Foundry

基　　金：国家自然科学基金项目(51271073);河南省重点攻关项目(102102210031)

摘　　要：在熔炼过程中以镁硅中间合金形式加入Si元素,研究了0～1.6%范围内不同Si含量对Mg-5Sn-1.5Al-1.2Zn镁合金铸态组织及力学性能的影响。结果表明:合金元素Si与Mg基体结合生成了强化相Mg2Si,并在该相周围有Mg2(Si,Sn)复合相产生,Mg2(Si,Sn)相的出现对Al、Zn元素形成τ-Mg32(Al,Zn)49相有促进作用;Si元素在0～1.6%变化时,试样合金的抗拉强度、伸长率呈现先升高后降低的趋势,当Si含量为1.0%时强度、塑性出现较佳配合,而合金的硬度则呈现持续增加,Si含量1.2%～1.6%范围内,硬度上升趋势变缓。The effects of silicon content on as-cast microstructure and mechanical properties of Mg-5Sn-1. 5Al-1.2Zn magnesium alloy were studied when silicon element was added into melt in the form of magnesiumsilicon interalloy with the range of 0-1.6%. The results indicate that Mg2Si is the strengthening phase made by combining alloying element silicon and magnesium matrix, and around Mg2Si phase Mg2（Si, Sn） composition is found, the emerging of Mg2（Si, Sn） advances the forming of ~r-Mg32（A1, Zn）49 that is produced by A1 and Zn elements. When Si element changes from 0 to 1.6%, tensile strength and elongation of the alloy display a trend which increase firstly and then decrease, its tensile strength and elongation match better when Si content is 1.0%, while hardness of the alloy is improved in the range of 0-1.6% Si, the increment of hardness becomes slow as S i content in the range of 1.2%-1.6%.

关 键 词：Mg-Sn-Al-Zn合金 Si 显微组织 力学性能 

分 类 号：TG146.22[一般工业技术—材料科学与工程]