检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:王淑琴[1] 殷淑娟[1] 许建霞[2] 邵安良[2] 奚廷斐[1,3,4]
机构地区:[1]温州医学院信息与工程学院,温州325035 [2]中国食品药品检定研究院,北京100050 [3]北京大学前沿交叉学科研究院生物医用材料与组织工程研究中心,北京100871 [4]北京大学深圳研究院,深圳518057
出 处:《药物分析杂志》2013年第4期701-705,共5页Chinese Journal of Pharmaceutical Analysis
基 金:"973"课题:医用镁合金材料的生物适配设计与降解调控机制研究(2012CB619102);国家科技支撑计划:全降解血管支架(金属镁基;聚乳酸)(2012BA1181301)
摘 要:目的:观察纯镁在不同体系中的降解行为,研究其在不同介质中不同的降解机制。方法:利用模拟体液(SBF)和细胞培养基(DMEM)分别作为纯镁的腐蚀介质,参照ASTM-G31-72标准选择相应体积的溶液进行浸泡,测量1 d、2 d、4 d、8 d和16 d各体系中钙镁离子浓度、pH改变,并通过扫描电镜、EDS和XRD等对材料表面形貌及物相进行分析。结果:在SBF模拟体液中浸泡的样品在第8 d已经成分散的颗粒状,看不到完整的样品。而DMEM中样品却仍然可以保持完整形貌。SBF溶液中镁离子的释放量及钙离子消耗量明显高于DMEM溶液。2种腐蚀介质中pH变化没有太大的差异,最终的pH都维持在10.0左右。纯镁在2种腐蚀介质中生成的产物有很大的差别。在SBF体系中,样品腐蚀产物主要是氢氧化镁,并出现了少量镁的磷酸盐沉淀。而在DMEM中,腐蚀产生了大量的磷酸一氢镁和磷酸镁,同时有少量的氢氧化镁结晶。结论:纯镁在2种体系中腐蚀速度差别很大,在SBF体系腐蚀速度明显大于DMEM体系中。纯镁在SBF体系和DMEM中不同时间点产生的腐蚀产物不同。Objective:To observe the corrosion behavior of pure magnesium in different corrosive media,and explore the possible degradation mechanism.Methods:According to ASTM-G31-72 standard used simulated body fluid(SBF) and Dulbecco's modify Eagle medium(DMEM)for immersion media to immerse pure magnesium.Measured calcium,magnesium ion concentration and system pH changes in the different time point.The changes of material surface morphology were investigated by scanning electron microscopy,EDS and XRD.Results: After immersing 8 days,the samples in SBF could not observe the complete shape,while the samples' shape were completed in DMEM.The magnesium ion release quantity and calcium consumption in SBF solution are obviously higher than that of the DMEM solution.The changes of pH in two kinds of corrosion medium did not present too big difference,and the pH was maintained at about 10.0 finally.The product of pure magnesium which soaked in the two kinds of corrosion medium presented big difference.Samples' surface in the SBF system generated magnesium hydroxide,and emerged a small amount of magnesium phosphate precipitation.While in DMEM,there has been a lot of magnesium monohydrogen phosphate,magnesium phosphate,and a small amount of magnesium hydroxide crystals.Conclusion:The SBF system of the corrosion rate was significantly higher than DMEM.Pure magnesium corrosion products generated differently at different time points in the SBF system and DMEM.
关 键 词:纯镁降解行为 腐蚀介质 模拟体液(SBF) 细胞培养基(DMEM) EDTA滴定法 植入材料 骨替代材料
分 类 号:R917[医药卫生—药物分析学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.225.72.113