检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]沈阳大学辽宁省先进材料制备技术重点实验室,辽宁沈阳110044
出 处:《沈阳大学学报(自然科学版)》2013年第2期123-127,共5页Journal of Shenyang University:Natural Science
基 金:国家自然科学基金资助项目(51171118);辽宁省自然科学基金资助项目(20111019);沈阳大学博士启动基金资助项目(20212339)
摘 要:通过座滴法研究了Sn-In、Sn-Bi和Sn-Ag-Cu三种焊料分别与块状非晶合金Zr44Cu40Al8Ag8的润湿行为.结果显示在三种焊料中,Sn-In对块状非晶合金Zr44Cu40Al8Ag8的润湿性最好,而Sn-Bi焊料对块状非晶合金Zr44Cu40Al8Ag8的润湿性最差.利用扫描电镜研究了Sn-In焊料与块状非晶合金Zr44Cu40Al8Ag8的界面特征,其界面处有化合物出现.During the joint of metallic glass, the most serious issue is the reformation of glassy phase at the high temperature area. To avoid the recrystallization of glassy phase, the soldering process has been investigated to join metallic glasses. The sessile drop method was used to study the wetting behavior and interracial characteristics of lead-free solders (Sn-In, Sn-Bi and Sn-Ag-Cu) on Zr44Cu40 Al8Ag8 metallic glass substrate in high vacuum. Results show that the Sn-In solder on Zr44 Cu40 Al8Ag8 metallic glass had better wetting characteristics than the Sn-Bi and Sn-Ag-Cu solders. Wettability of Sn-Bi solder on Zr44Cu40Al8Ag8 metallic glass was the worst in three lead-flee solders. The microstructure at the interface between Sn-In solder and Zr44 Cu40 Al8Ag8 metallic glass was analyzed by scanning electron microscopy. It was clear that the intermetallic compound was formed at the interface.
分 类 号:TG146[一般工业技术—材料科学与工程] TG491[金属学及工艺—金属材料]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.3