检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:叶繁[1] 薛飞彪[1] 褚衍运[1] 司粉妮[1] 胡青元[1] 宁家敏[1] 周林[1] 杨建伦[1] 徐荣昆[1] 李正宏[1] 许泽平[1]
机构地区:[1]中国工程物理研究院,核物理与化学研究所,绵阳621900
出 处:《物理学报》2013年第17期323-328,共6页Acta Physica Sinica
基 金:国家自然科学基金(批准号:11135007,11005096,11275030);中国博士后科学基金(批准号:2012M511945)资助的课题~~
摘 要:负载内外层电流分配是决定双层丝阵Z箍缩内爆动力学模式的关键因素.在"强光一号"装置上,利用微型磁探针系统定量测量了双层钨丝阵三个重要径向位置点的电流,获得了其在驱动电流开始上升至驱动电流达到峰值之前20ns这一阶段内的时间演化行为.实验使用的双层钨丝阵负载高度为20 mm、单丝直径为3.8μm、内/外层丝阵直径分别为8 mm/16 mm.对比了内/外层丝根数分别为42/21和21/42时电流分配的差异.结果表明:驱动电流上升过程中,内外层丝阵的电流均逐步增大,外层丝阵电流份额逐渐减小,而内层丝阵电流份额逐渐增大;内层丝阵最大电流份额未超过50%;内/外层丝根数为21/42的负载外层电流较大.The current division between the inner and the outer arrays is one of the key factors that impact the implosion dynamics and modes of nested wire array. This paper presents the first quantitative measurements of current division for nested wire array Z pinch on the Qiang Guang-I pulsed power facility. In experiments, the nested wire arrays, made of 3.8 gm-diameter tungsten wires, were 20 mm in height and 8 mm/16 mm in diameter for inner/outer array. Measurements for loads consisting of 42/21 wires in inner/outer array were compared with that of 21/42 in inner/outer array. Data of current versus time at various radial positions were obtained using magnetic probes until 20 ns before the current peak. Results show that the currents in inner and outer arrays increase during the rise of the driving current, the proportion of current in outer array decreases and that in inner array increases, while the current in outer array, for loads with 21/42 wires in inner/outer array, was larger than those with 42/21 wires in inner/outer array.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.229