检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
出 处:《中南林业科技大学学报》2013年第9期98-102,共5页Journal of Central South University of Forestry & Technology
基 金:科技部科技人员服务企业行动计划项目(SQ2009GJD2005258)
摘 要:采用响应面Box-Benhnken中心组合试验设计与分析方法,对PF树脂浸渍杨木单板的工艺因素进行了分析,建立了浸渍工艺因素与单板增重率之间关系的二次回归模型。方差分析表明,二次回归模型高度显著,计算值与实际值之间的误差很小。抽真空时间、胶液浓度和常压浸渍时间对单板增重率具有高度显著的影响,上述因素的交互项对单板增重率影响很小。RSA得到的优化工艺参数为抽真空时间为20 min,胶液浓度为28%,常压浸渍时间为3.0 h,以上述工艺参数进行重复验证试验,试验结果与二次回归模型的计算结果误差很小,表明二次回归模型的预测是可靠的。Abstraet: The technology factors, which affect the impregnation result of PF resin into poplar veneer, were investigated through the response surface Box-Benhnken centre combination tests, and the quadratic regression model, on the relationship between impregnation technology factors and weight gain rate of veneers, was established. The variance analysis results show that the quadratic regression model was highly significant, the errors between calculated value and actual value was very small, and the pump-down time, concentration of resin and impregnation time in ordinary pressure significantly affected the weight gain rate of the veneers, but the interactive items as above factors had scarcely any effects to the weight gain rate of veneers. The optimized technology factors through RSA were: vacuumizing time 20 min, concentration of resin 28%, and impregnation time in ordinary pressure 3.0 hours which were tested repeatedly for confirmation. The findings show that there was very small error between the calculated value by quadratic regression model and the test value. Key words: poplar veneer; PF resin; response surface; weight gain rate
分 类 号:S792.11[农业科学—林木遗传育种] S781.6[农业科学—林学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.38