5083铝合金搅拌摩擦焊焊核区非均匀性组织分析  

Research on Heterogeneity Microstructure of 5083 Aluminum in Nugget Zones after Friction Stir Welding

作　　者：梁春朗[1] 袁鸽成[1] 吴红辉[1] 吴亚 

机构地区：[1]广东工业大学材料与能源学院,广东广州510006

出　　处：《广东工业大学学报》2013年第3期118-121,共4页Journal of Guangdong University of Technology

基　　金：广东省重大科技专项资助项目(2008A090300004);广东省教育厅211工程学科建设资助项目(412110903)

摘　　要：利用小型搅拌摩擦焊机焊接5083铝合金板材,借助电子背散射衍射技术和取向成像分析软件对焊缝焊核区的焊核前进侧、焊核中心区和焊核后退侧的晶粒形貌和取向差角度进行了对比性研究.结果表明:经过搅拌摩擦焊接后,焊核区发生动态再结晶,晶粒由原始带状转变为等轴状,其大角度晶界含量相比于母材有明显增加,但不同部位的晶粒尺寸和大角度晶界比例均不同,焊核前进侧、焊核中心区和焊核后退侧的平均晶粒尺寸分别为17.0、15.8和13.5μm,大角度晶界比例分别为76.4%、68.8%和73.2%.The 5083-H321 aluminum magnesium alloy plates were welded on a minitype friction stir weld- ing machine. The mierostructure of friction stir welding （FSW） in each nugget zone was studied via the grain morphology and misorientation distribution of nugget advancing side, nugget median zone and nug- get retreating side. The results show that there are small equiaxial grains into which lath-shaped grains turn in nugget zones after friction stir welding. However, there are differences in the grain size between the nugget advancing side, nugget median zone and nugget retreating side, and the average grain sides are 17, 15.8 and 13.5 μm, respectively. Compared with the base metal, the high angle grain bounda- ries （HAGB） fraction in nugget zones increase. Meanwhile the content is also different in the three zones, and they are 76. 4% , 68.8% and 73.2% , respectively.

关 键 词：搅拌摩擦焊 焊核前进侧 焊核中心区 焊核后退侧 微观组织 

分 类 号：TG146.21[一般工业技术—材料科学与工程]