PIXE方法在地质样品测定中实验流程的开发和评价  

Development and evaluation of experimental process of PIXE method for geological samples

作　　者：张建东[1,2,3] 邵拥军[1,2] 石山大三 

机构地区：[1]中南大学地球科学与信息物理学院,长沙410083 [2]中南大学有色金属成矿预测教育部重点实验室,长沙410083 [3]秋田大学工学资源学研究院,环境资源研究中心

出　　处：《中国有色金属学报》2013年第9期2693-2703,共11页The Chinese Journal of Nonferrous Metals

基　　金：国土资源部公益性行业科研专项经费资助项目(200911007-04);国家危机办项目(20109901);国家重点基础研究发展计划资助项目(2007CB411405);国家"十一五"科技支撑计划资助项目(2006BA01B07);中南大学有色金属成矿预测教育部重点实验室发展基金的联合资助项目

摘　　要：利用质子荧光分析（PIXE）方法在聚碳酸酯薄膜上测定了日本地质调查局标准岩石和矿石样品的化学组分，样品为细粒、微量的（1-2mg）粉末地质样品。PIXE测试的结果表明：对标准岩石样品而言，具有0．4μm孔径薄膜的测定值与其他孔径薄膜（0．2，0．6和0．8μm）的测定值相比，其相对岩石标样的参考值变化更小，更适合作为理想样靶被采用；对标准矿石样品而言，0．2μm孔径薄膜的测定值与矿石标样的参考值相比，更适合作为理想的样靶。日本地质调查局标准岩石和矿石样品测定的化学组分总是稍微不同于标准样品的参考值，因此计算了测定值和参考值之间的校正因子，通过校正因子的调整，针对量少的岩石和矿石粉末样品，就可以获得较为精确的测试结果。Chemical analyses of fine-grained powder samples from the Geological Survey of Japan （GSJ） trapped on a polycarbonate filter were carded out by particle induced X-ray emission （PIXE） to measure the chemical compositions of geological samples having small amounts （1-2 mg）. The variability of results obtained by using a filter with a pore size of 0.4 μm was smaller than the variability of results obtained by using filters with pore sizes of 0.2, 0.6 and 0.8 μm for rock samples. The results obtained by using filter with a pore size of 0.2 μm are better than the results obtained by using filters with pore sizes of 0.4, 0.6 and 0.8 μm for ore samples. The results of chemical analysis of powder samples of Japanese rock standards by PIXE are slightly different from certified values by the Geological Survey of Japan because of self-absorption of characteristic X-rays in measurements. Calibration factors were calculated on the basis of the measured values and certified values. The use of these calibration factors enables accurate results to be obtained for small amounts of powder samples of rocks and ores.

关 键 词：质子荧光分析(PIXE) 过滤薄膜 孔径 校正因子 

分 类 号：P632[天文地球—地质矿产勘探]