GH3230高温合金氩弧焊接接头的组织与高温性能  

High-Temperature Properties and Microstructure of Argon-Arc Welded Joint of GH3230Superalloy

作　　者：张冬旭[1] 刘大顺[1] 朱西平[1] 温志勋[1] 岳珠峰[1] 陆波[2] 

机构地区：[1]西北工业大学工程力学系先进材料测试中心,西安710129 [2]中国航空动力机械研究所,株洲412002

出　　处：《机械工程材料》2013年第12期35-37,41,共4页Materials For Mechanical Engineering

基　　金：国家自然科学基金资助项目(50905143);陕西省自然科学研究计划项目(2010JQ1001);研究生种子基金资助项目(Z2012065)

摘　　要：通过扫描电镜、高温拉伸试验机和高温蠕变试验机等对GH3230高温合金钨极氩弧焊接接头的显微组织和高温性能进行了研究。结果表明:焊缝组织主要由平衡凝固γ-FeCrNiC镍基固溶体、少量的颗粒状γ′-Ni3Al和MC碳化物组成,呈等轴树枝状;热影响区的组织与母材的相当,但晶粒更粗大;焊接接头具有良好的高温性能,其在927℃下的高温抗拉强度为244MPa,与母材的相当,在927℃和62MPa下的高温蠕变寿命为38.82h,高于母材的;高温拉伸和高温蠕变试验后的接头断口形貌与母材的基本一致,分别为韧窝型和沿晶断裂。The high temperature properties and microstructure of GH3230 alloy argon arc welded joint were investigated by SEM, high temperature tensile test and high temperature creep test. The results indicate that the equiaxial dendritic microstructure of welded seam was made up of equilibrium frozen Ni based solid solution, γ-FeCrNiC, a little bit granular carbides, γ＇-Ni3 A1 and MC. The microstructure in heat affected zone was the same as in the base metal, but grains in heat affected zone was bigger than in the base metal. The joint exhibited good high temperature properties with a tensile strength of 244 MPa at 927℃, as same as the base metal, and a creep life of 38.82 h at 927℃ and 62 MPa which was higher than the base metal. The fracture morphology of welded joints after high temperature tensile test and creep test were basically identical which were dimple and intergranular fracture, respectively.

关 键 词：GH3230高温合金 氩弧焊 高温蠕变 

分 类 号：TG457.19[金属学及工艺—焊接]