检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:梁静[1] 赵青春 于冰[3] 胡立锦 赵伟 常喜强[3]
机构地区:[1]国网新疆电力公司电力科学研究院,新疆乌鲁木齐830002 [2]南瑞继保电气有限公司,江苏南京210000 [3]国网新疆电力公司电力调度控制中心,新疆乌鲁木齐830002 [4]国网重庆电力公司建设分公司,重庆410021
出 处:《四川电力技术》2013年第6期29-32,38,共5页Sichuan Electric Power Technology
摘 要:提出了由于电网结构差异较大,负荷结构和电源布局不均匀导致线路区外对称故障时可能出现较大的零序电流,进而导致线路高频保护误动作的思考。理论推导了对称故障下出现零序电流的原因,在此基础上搭建了仿真模型进行仿真。理论分析和仿真结果表明线路系统区外对称故障下零序电流的最大确实会导致被保护线路高频保护误动。以新疆某地区实际电网为模型,沿用系统参数设置,采用在线和离线的方法调节系统负荷及电源投入情况,模拟并分析出现的高频保护误动情况,进而针对模拟情况提出合理的预防建议和措施。A stronger zero - sequence current may occur when the symmetrical fault appears outside the line zone due to the different structure of power grid, uneven load structure and power distribution, which results in the misoperation of high - fre- quency protection. The reasons why zero - sequence current occurs under symmetrical fault are analyzed by theoretical deriva- tion, and the simulation model is established. The theoretical analysis and simulation results show that the maximum zero - se- quence current under symmetrical fault outside the line zone will exactly cause the misoperation of high - frequency protection in the protected line. Taking the actual power grid as the model in one place of Xinjiang, the misoperation of high - frequency protection is simulated and analyzed by following the setting of system parameters and adopting the on - line and off - line methods to control the system load and the power source connection, thus the reasonable preventive suggestions and measures are put forward.
分 类 号:TM773[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.147