大型轴类锻件新型凸面砧拔长研究  

The Design of a New Convex Anvil in Blank Making Process on Heavy Shaft Forgings

作　　者：栗玉杰 安红萍[1] 云晖[1] 赵晓东[1] 

机构地区：[1]太原科技大学材料科学与工程学院,太原030024

出　　处：《太原科技大学学报》2013年第6期429-434,共6页Journal of Taiyuan University of Science and Technology

基　　金：太原科技大学博士基金(20122057);山西省青年科技研究基金(2012021019-6)

摘　　要：拔长是大型轴类锻件成型的重要工序。本文针对其锻造中拔长过程,研究了一种新的型砧,以期改善拔长时工件应力应变状态,提高锻件内在质量。并应用有限元分析软件deform-3D进行数值模拟,分别研究了型砧角度α、砧宽比对锻件内部应力、应变的影响,列出了对比试验结果。从而确定了基本的型砧参数。Drawing is an important process of large shaft forgings. Aiming at drawing process in the forging process, a new anvil was designed to to improve the stress and strain state of workpiece in the drawing process, as well as the internal quality of forgings. The effects of anvil＇s angle and anvil width ratio on forging deformation and inner stress were studied by applying finite element analysis software deform-3 D, and the contrast simulation results were listed. Then the basic parameters of the anvil were defined.

关 键 词：大型轴类锻件 型砧 砧宽比 DEFORM-3D 

分 类 号：TG315.12[金属学及工艺—金属压力加工]