工艺参数对挤出成型的影响分析  

Infl uence Analysis of Process Parameters on Extrusion

作　　者：张广冬[1] 郝昕玉[1] 

机构地区：[1]盐城工学院机械工程学院,江苏盐城224051

出　　处：《工程塑料应用》2014年第1期68-70,共3页Engineering Plastics Application

摘　　要：采用有限元方法分析了工艺参数中入口流量和壁面滑移对挤出成型的影响,特别是对挤出压力降,挤出胀大比以及模流平衡系数等重要指标的影响。结果表明,随着入口流量的增大,模流平衡系数增大,同时模具型腔内的压力降也线性增大。壁面滑移的存在有利于减小挤出模内的速度梯度,从而减小挤出胀大比和模流平衡系数。Finite element analysis method was used to analyze the influence of the inlet flow and wall slip on the extrusion, especially for the extrusion pressure drop, extrusion swell ratio and dies balance coefficient etc. The result show that with the increase of the inlet flow, die balance coefficient increases, while the mold cavity pressure drop also is increased linearly. The existence of wall slip is conducive to reduce the velocity gradient inside the extrusion die, thereby reducing the extrusion die swell ratio and die balance coefficient.

关 键 词：挤出成型 工艺参数 挤出胀大比 模流平衡系数 

分 类 号：TQ320.663[化学工程—合成树脂塑料工业] TP391.9[自动化与计算机技术—计算机应用技术]