检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:麻敏华[1] 汪晶毅[2] 李志泰[2] 潘春平[2]
机构地区:[1]广东电网公司电网规划研究中心,广东广州510080 [2]中国能源建设集团广东省电力设计研究院,广东广州510663
出 处:《中国电力》2014年第1期23-27,共5页Electric Power
摘 要:为有效提高单位走廊的输送容量,同塔多回路输电技术得到越来越广泛的应用,但是由于换位困难,一旦相序布置不当将造成线路电气不平衡情况更为严重。采用ATP-EMTP和MATLAB程序对500 kV同塔四回路3层横担和6层横担2种塔型的电气不平衡度展开了较为全面的研究。综合考虑负序电压电流不平衡度、杆塔的雷击跳闸率、电磁环境等指标,建议3层横担塔型采用推荐的相序布置方式、6层横担塔型上下两个双回路均采用逆相序布置。计算还表明,对500 kV同塔四回路,单回路停电检修时的感应电压和电流较高,选择接地开关时应予以特别关注。In order to increase transmission capacity of electric power corridor significantly,multi-circuit on the same tower was constructed more and more widely in developed area.However,it's difficult to realize transposition for multi-circuit on the same tower because of complex conductors arrangement,and electric unbalance degree of the transmission lines would get worse if phases were arranged inappropriately.ATP-EMTP and Matlab programs were applied to electric unbalance degree calculation for the three-layer and six-layer cross-arms tower of 500 kV four circuits on the same tower.According to the comparison of negative sequence voltage and current,lightning trip-out rate and electromagnetic environment,better electric unbalance degree was achieved when commendatory phase arrangement was adopted on three-layer cross-arms tower and diverse phase sequence was chosen on six-layer cross-arms tower.The results also showed that induce voltage and induced current from energized circuits got high when single circuit was maintained.It should be paid much attention to isolated switches selection.
关 键 词:500 kV同塔四回路 电气不平衡度 负序电压电流 雷击跳闸率 感应电压 感应电流 逆相序
分 类 号:TM75[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.200