检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:梁金明[1] 唐荻[1] 武会宾[1] 张鹏程[1] 柳伟[2] 毛红艳[1] 刘晓童
机构地区:[1]北京科技大学高效轧制国家工程研究中心,北京100083 [2]北京科技大学材料科学与工程学院,北京100083
出 处:《华南理工大学学报(自然科学版)》2013年第10期72-78,91,共8页Journal of South China University of Technology(Natural Science Edition)
基 金:国家科技重大专项(2011ZX05016-004);国家"十二五"科技支撑计划项目(2011BAE25B00)
摘 要:为探究货油舱下底板环境中的腐蚀机理并开发满足该服役条件的的低合金耐蚀钢,采用自制的货油舱下底板强酸性Cl-溶液模拟腐蚀装置,进行Cr含量不同的低合金钢的腐蚀行为研究.测量了模拟腐蚀实验中各合金钢的平均腐蚀速率,观察了实验后各试样表面的宏观形貌,应用SEM、EDS对腐蚀表面的微观形貌及元素分布进行了分析,并应用EBSD和TEM技术分析了钢的微观结构对该环境下腐蚀性能的影响,同时对不同Cr含量的低合金钢进行了极化曲线和交流阻抗谱分析.结果表明:货油舱下底板环境中,Cr含量为1%~3%时,腐蚀速率随着Cr含量的升高逐渐增大,点蚀现象随之变得明显;随Cr含量的增加,合金钢中的小角度低能晶界含量增加,同时钢的局部位错密度增加,两种微观结构综合作用促使腐蚀速率增大;腐蚀实验结果与电化学分析结果是对应的.In order to reveal the corrosion mechanism of the bottom plate environment of cargo oil tanks and to develop new low-alloy steels under such environment,a home-made cargo oil tank corrosion simulation device with the strong-acid C1-solution corrosion on the bottom plate,was used to investigate the corrosion behaviors of low-alloy steels with different Cr contents.Specifically,the average corrosion rates of the steels in the corrosion test were measured with the corresponding morphology observation,and the micromorphologies and element distributions of the steels were characterized respectively by means of SEM and EDS.Moreover,the effect of the steel microstructure on the corresponding corrosion-resistance was analyzed by means of EBSD (Electron Backscattered Diffraction)and TEM,and the polarization curves and AC impedance spectroscopy of the steels with different Cr contents were tested.The results show that (1) when the Cr content increases within a range of 1% ~ 3% in the bottom plate environment,the corrosion rate gradually increases and the surface pitting phenomenon becomes obvious; (2) with the increase of the Cr content,the proportion of small-angle low-energy grain boundary and the dislocation density both improve,and the changes of the two microstructures both play their roles in the increase of the corrosion rate ;and (3) the corrosion test results accord well with the electrochemical analysis results.
分 类 号:TG172[金属学及工艺—金属表面处理]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.179