检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]武汉大学动力与机械学院,湖北武汉430072
出 处:《热力发电》2014年第1期61-65,121,共6页Thermal Power Generation
摘 要:采用静态浸泡实验研究了3种大孔阴树脂强碱基团降解速率与温度、水料倍率的关系,探讨阴树脂的降解动力学.研究结果表明:不同树脂开始降解的温度不同,阴树脂在60~80℃范围内降解速率明显加快且随着温度升高而增加;在较低的水料倍率下(≤200∶6),降解反应较好地遵循零级反应动力学;水料倍率会影响阴树脂的降解速率,水料倍率增大,强碱基团降解加速.Factors affecting the thermal degradation rate of anion exchange resin were discussed by static immersion test,such as temperature and water-resin ratio (soak solution and resin quality ratio). The results showed that, the degradation reaction followed the zero-order kinetics well when the water-resin ratio was not higher than 200 : 6 within temperature range from 60 ℃ to 80℃ Strong-base loss rate increased with the temperature and water-resin ratio. In addition, stat- ic immersion test should try to eliminate the effect of water-resin ratio, which will make the heat resistance results reflect and guide the actual production better.
关 键 词:大孔阴树脂 强碱基团 耐热性能 降解动力学 温度 水料倍率 降解速率
分 类 号:TM621.8[电气工程—电力系统及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.42