Characteristics of greenhouse gas emission in three full-scale wastewater treatment processes  

作　　者：Xu Yan Lin Li Junxin Liu 

机构地区：[1]Department of Water Pollution Control Technology, Research Center for Eco-Environmental Sciences, Chinese Academy of Sciences

出　　处：《Journal of Environmental Sciences》2014年第2期256-263,共8页环境科学学报（英文版）

基　　金：supported by the National Natural Science Foundation of China (No. 51138009)

摘　　要：Three full-scale wastewater treatment processes, Orbal oxidation ditch, anoxic/anaerobic/aerobic （reversed A^2O） and anaerobic/anoxic/aerobic （A^2O）, were selected to investigate the emission characteristics of greenhouse gases （GHG）, including carbon dioxide （CO2）, methane （CH4） and nitrous oxide （N2O）. Results showed that although the processes were different, the units presenting high GHG emission fluxes were remarkably similar, namely the highest CO2 and N2O emission fluxes occurred in the aerobic areas, and the highest CH4 emission fluxes occurred in the grit tanks. The GHG emission amount of each unit can be calculated from its area and GHG emission flux. The calculation results revealed that the maximum emission amounts of CO2, CH4 and N2O in the three wastewater treatment processes appeared in the aerobic areas in all cases. Theoretically, CH4 should be produced in anaerobic conditions, rather than aerobic conditions. However, results in this study showed that the CH4 emission fluxes in the forepart of the aerobic area were distinctly higher than in the anaerobic area. The situation for N2O was similar to that of CH4： the N2O emission flux in the aerobic area was also higher than that in the anoxic area. Through analysis of the GHG mass balance, it was found that the flow of dissolved GHG in the wastewater treatment processes and aerators may be the main reason for this phenomenon. Based on the monitoring and calculation results, GHG emission factors for the three wastewater treatment processes were determined. The A^2O process had the highest CO2 emission factor of 319.3 g CO2/kg CODremoved, and the highest CH4 and N2O emission factors of 3.3 g CH4/kg CODremoved and 3.6 g N2O/kg TNremoved were observed in the Orbal oxidation ditch process.Three full-scale wastewater treatment processes, Orbal oxidation ditch, anoxic/anaerobic/aerobic （reversed A^2O） and anaerobic/anoxic/aerobic （A^2O）, were selected to investigate the emission characteristics of greenhouse gases （GHG）, including carbon dioxide （CO2）, methane （CH4） and nitrous oxide （N2O）. Results showed that although the processes were different, the units presenting high GHG emission fluxes were remarkably similar, namely the highest CO2 and N2O emission fluxes occurred in the aerobic areas, and the highest CH4 emission fluxes occurred in the grit tanks. The GHG emission amount of each unit can be calculated from its area and GHG emission flux. The calculation results revealed that the maximum emission amounts of CO2, CH4 and N2O in the three wastewater treatment processes appeared in the aerobic areas in all cases. Theoretically, CH4 should be produced in anaerobic conditions, rather than aerobic conditions. However, results in this study showed that the CH4 emission fluxes in the forepart of the aerobic area were distinctly higher than in the anaerobic area. The situation for N2O was similar to that of CH4： the N2O emission flux in the aerobic area was also higher than that in the anoxic area. Through analysis of the GHG mass balance, it was found that the flow of dissolved GHG in the wastewater treatment processes and aerators may be the main reason for this phenomenon. Based on the monitoring and calculation results, GHG emission factors for the three wastewater treatment processes were determined. The A^2O process had the highest CO2 emission factor of 319.3 g CO2/kg CODremoved, and the highest CH4 and N2O emission factors of 3.3 g CH4/kg CODremoved and 3.6 g N2O/kg TNremoved were observed in the Orbal oxidation ditch process.

关 键 词：wastewater treatment greenhouse gas carbon dioxide methane nitrous oxide emission factor 

分 类 号：X703[环境科学与工程—环境工程]