轴流压气机小流量状态转子叶尖泄漏涡的三维流动  

THREE-DIMENSIONAL FLOW OF THE TIP LEAKAGE VORTEX INSIDE AN AXIAL-FLOW COMPRESSOR ROTOR PASSAGE AT A LOW MASS-FLOW CONDITION

作　　者：马宏伟[1] 蒋浩康[1] 

机构地区：[1]北京航空航天大学动力系,北京100083

出　　处：《工程热物理学报》2001年第1期31-35,共5页Journal of Engineering Thermophysics

基　　金：国家重点基础研究发展规划项目!(No.G1999022305);国家自然科学基金资助项目!(No.59776009);航空基金

摘　　要：用三维激光多普勒测速系统测量了低速大尺寸单级压气机小流量状态转子内尖区三维紊流流场。小流量状态下叶尖泄漏涡产生于更靠近转子叶片前缘，旋涡强度大，发展迅速，在转子内距离前缘约２０％轴向弦长的截面达到最强，在８０％轴向弦长附近发生破裂。泄漏涡是造成转子内尖区流动阻塞和紊流脉动的主要因素之一。在约７５％弦长的轴向截面，吸力面角区发生旋涡流动，造成较强的流动阻塞和紊流脉动。Three-dimensional flow of the tip leakage vortex inside an axial-flow compressor rotor passage was studied using a 3-D Laser Doppler Velocimetry. The measurements were conducted in a low-speed large-scale compressor at a low mass-flow condition. The flow was surveyed across the entire passage at fifteen axial locations (leading edge to trailing edge) and twelve radial locations (0.985, 0.980, 0.975, 0.950, 0.925, 0.900, 0.875, 0.850, 0.813, 0.775, 0.738 and 0.700 spans). The measurement results indicated that the tip leakage vortex is produced very close to the leading edge, and becomes strongest at about 20% axial chord from the leading edge. With the flow downstream, the vortex core migrates to the pressure surface and to a lower radial location, leading to substantial flow blockage and turbulence. Breakdown of the leakage vortex occurs at about 80% axial chord. A separation vortex appears at the corner of the tip suction surface at about 75blockage and mixing at the downstream tip corner.

关 键 词：轴流压气机 叶尖泄漏涡 三维流动 小流量状态转子 

分 类 号：TH45[机械工程—机械制造及自动化]