T型口模气辅挤出中影响挤出胀大的因素分析  

Analysis of Influence Factors of Die-Swell in T-shape Die Gas-Assisted Extrusion

作　　者：宋建辉 黄兴元[2] 

机构地区：[1]中山市广播电视大学文理系,广东中山528403 [2]南昌大学聚合物加工研究室,江西南昌330031

出　　处：《塑料》2014年第2期72-74,共3页Plastics

基　　金：中山市科技计划项目资助(20114A260)

摘　　要：以T型截面异型材为对象,结合正交试验表L16(43)用数值模拟方法对气辅挤出成型中滑移段长度、挤出流量和松弛时间对挤出胀大的影响进行研究,结果表明:气辅挤出段长度对挤出胀大的影响最大,其次为松弛时间,挤出流量的影响最小,增加气辅挤出段长度、减小挤出流量和松弛时间可以减小挤出胀大。The influence of gas-assisted length, flow rate and relaxation time on the die swell had been studied by means of orthogonal experiment table L16 （4^3 ） and numerical simulation for the T-shape plastic profile. The influence on the die swell showed that the greatest was the gas-assisted extrusion length, the next was the relaxation time and the least was the flow rate. The die swell could be reduced by increasing the gas-assisted extrusion length and decreasing the relaxation time and flow rate.

关 键 词：气辅挤出 T型异型材 挤出胀大 正交试验 数值模拟 

分 类 号：TQ320.663[化学工程—合成树脂塑料工业]