Fe 2＋对聚合物的影响及其处理方法研究  

Effect of Fe^(2+) on the apparent viscosity of polymer solution and controlling methods

作　　者：陈斌[1] 吴晓燕[1] 王姗姗 陈士佳[1] 左清泉[1] 

机构地区：[1] 中海油能源发展钻采工程研究院 [2] 中海油研究总院

出　　处：《石油与天然气化工》2014年第2期168-173,共6页Chemical engineering of oil & gas

基　　金：“十一五”国家重大专项“大型油气田及煤层气开发”子课题“海上稠油化学驱油技术”(2008ZX05024-002)

摘　　要：研究了配聚水中Fe2+的浓度对HPAM溶液黏度的影响机理,实验结果表明,随着溶液中Fe2+浓度增大,聚合物的相对分子质量和溶液的黏度呈下降趋势;当ρ(Fe2+)为0~0.5mg/L时,HPAM的相对分子质量、黏度随Fe2+浓度的增加而大幅度下降;当ρ(Fe2+)超过0.5mg/L时,下降趋势变缓;同时,原子力显微镜照片(AFM)显示,含ρ(Fe2+)0.5mg/L的聚合物溶液的网状结构也受到较大的破坏。为确保聚合物溶液的黏度,配聚水中ρ(Fe2+)应控制在0.5mg/L以下,采用自然曝氧法、化学络合法和锰砂接触过滤法都可以达到除铁效果,其中以化学除铁法最为简单有效;使用高效除铁络合剂BHCT-1,加药质量浓度只需300mg/L就可以取得良好的除铁效果,海上注聚油田现场应用效果良好,聚合物溶液黏度提高20%以上。The influences of Fe2＋ on the apparent viscosity of polymer solution have been stud-ied in this paper ,and the results showed that a small amount of Fe2＋ would make the polymer degraded severely .HPAM polymer molecular weight and viscosity declined dramatically with the increasing of CFe2＋ among the 0~0 .5 mg/L ,and declined slowly when the CFe2＋ above a concen-tration of 0 .5mg/L .The AFM photos also showed that polymer network structure was destroyed largely .In order to ensure the polymer viscosity , the contents of Fe2＋ in preparation water should not exceed to the concentration of 0 .5 mg/L .There are several controlling measures used to remove Fe2＋ in preparation water ,such as oxygen exposure ,chemical complex method and manganese sand filtration .Chemical complex method is the most simple and effective one among them .The high effective iron removal reagent BHCT-1 with a concentration of 300 mg/L showed a good effect to remove Fe2＋ .For example ,it was applied in offshore polymer flooding oilfield , and the viscosity of polymer solution would be increased by more than 20% .

关 键 词：聚丙烯酰胺 降解作用 表观黏度 除铁 

分 类 号：TE39[石油与天然气工程—油气田开发工程]