纳米技术合成硅酸三钙及表征  

Synthesis and Characterization of Tricalcium Silicate by Nanotechnology Route

作　　者：豆贝贝 刘志刚[1] 杨立荣[1] 姚少威[1] 白瑞英[1] 封孝信[1] 

机构地区：[1]河北联合大学材料科学与工程学院,河北唐山063009

出　　处：《河北联合大学学报（自然科学版）》2014年第2期67-70,共4页Journal of Hebei Polytechnic University:Social Science Edition

基　　金：河北联合大学博士启动基金项目

摘　　要：以硅溶胶、硝酸钙为原料,尿素为燃料,采用燃烧法制备纳米硅酸三钙。研究了化学计量比、引燃温度对合成产物中游离氧化钙含量的影响。用乙二醇法测定产物中游离氧化钙的含量,X射线衍射仪、场发射扫描电镜、Zeta电位及纳米粒度分析仪和微量热仪表征合成样品的物相、微观形貌、粒度分布和水化热。结果表明:化学计量比为0.24,引燃温度为700℃时,合成产物中游离氧化钙含量达到最低值2.0%;合成的纳米硅酸三钙颗粒为不同结晶程度且呈现多种形貌的颗粒,平均粒度为225.9 nm;合成的纳米硅酸三钙水化放热峰值出现的时间为69.2 s,峰值为2.4368 mw/g,比传统水泥具有较高的水化活性。Nano tricalcium silicate （nano- C3S） was synthesized by a combustion method with silica sol and calcium nitrate as raw materials ,urea as fuel. Effects of stoichiometric ratio and ignition temperature on the content of f-CaO in synthesized nano- C3 S were investigated. The content of f-CaO in synthesized samples was measured by glycol method. The phase composition, microstructure , particle size distribution and hydration heat of samples were charac- terized by X-ray diffractometer （XRD） ,Field emission scanning electron microscope （FSEM） ,Zeta potential/sub- micron size analyzer and Digital display calorimeter. The results show that the content of f-CaO in the sample reaches the least value about 2.0% under the synthesized condition of stoichiometric ratio at 0.24 and the ignition temperature at 700 ℃. The synthesized nano- C3 S particles show various morphology and diverse degree of crystallization with an average particle＇ size of 225.9nm. The synthesized nano- C3S shows a higher hydration reactivity in comparision with traditional cement because the value of the heat evolution peak of the product is 2. 4368 mw/g at a hydration time of 69.2 seconds.

关 键 词：纳米硅酸三钙 燃烧法 粒度分布 水化热 

分 类 号：TQ172[化学工程—水泥工业]