顺层岩体边坡地震动力破坏离心机试验研究  

CENTRIFUGE MODELLING TESTS ON DYNAMIC FAILURE OF BEDDING ROCK SLOPES

作　　者：李祥龙[1,2] 唐辉明[1] 王立朝[2] 

机构地区：[1]中国地质大学工程学院,湖北武汉430074 [2]中国地质环境监测院,北京100081

出　　处：《岩石力学与工程学报》2014年第4期729-736,共8页Chinese Journal of Rock Mechanics and Engineering

基　　金：中国地质调查局"汶川地震区岩体稳定性研究"项目(1212010914036);国家科技支撑计划课题(2011BAK12B09)

摘　　要：使用相似材料分别制作只含有非连续的层面和同时含有非连续的层面和非贯通的次级节理顺层岩体边坡小比例物理模型,进行离心机动力试验,研究边坡的动力响应和破坏机制以及非连续层面和次级节理对其的影响。试验结果证明:顺层边坡的动力响应对地震波的频率和边坡内部结构面的发育特征敏感,边坡结构面发育越复杂,边坡对地震波的频率响应越复杂,地形放大效应也越明显;顺层边坡的动力稳定性和破坏机制受结构面发育特征控制,含有次级节理的边坡动力稳定性更低,破坏范围也更浅,在破坏过程中还会出现次级节理的张拉破坏导致的岩体内部解体破碎,可能诱发岩石碎屑流。Two types of physical models of sliding rock slope, one with the intermittent rock planes alone and the other with both the rock planes and secondary rock joints were built using similar materials, and tested in the centrifuge machine under different seismic loads. The dynamic response and failure mechanism of the two slope models were then recorded and analyzed. The test results revealed that the dynamic response of the sliding rock slope was sensitive to the frequency of input seismic load and the characteristics of the joint structure inside. The more complex the joint structures are, the more complex the response to the input load frequency and the greater the topographic amplification effect. The dynamic stability and failure mechanism is strongly affected by the joint structure characteristics of the rock slope mass. The rock slope model with both intermittent rock bedding planes secondary rock joints has the lower dynamic stability and a shallower failure plane than the model with only the bedding planes. The tensile failures of the secondary rock joints during the dynamic failing process give rise to the internal crash and lead to the rock debris flow.

关 键 词：边坡工程 顺层岩体边坡 动力 离心机模型试验 正交次级节理 

分 类 号：P642[天文地球—工程地质学]