热加工参数对GH738合金动态再结晶行为的影响  

Effects of Hot Working Parameters on Dynamic Recrystallization Behaviors of GH738 Alloy

作　　者：刘辉[1] 蔡新宇[1] 

机构地区：[1]中国航空工业集团公司沈阳黎明航空发动机(集团)有限责任公司,辽宁沈阳110016

出　　处：《钢铁研究学报》2014年第3期46-50,共5页Journal of Iron and Steel Research

摘　　要：采用Gleeble-1500D热加工模拟试验机及微观组织分析系统研究了热加工参数对GH738合金动态再结晶组织分布的影响规律。结果表明:影响GH738合金动态再结晶晶粒分布均匀性的主要因素是变形量,当变形量大于50%且接近70%时更易获得较均匀的再结晶组织。变形速度及温度对动态再结晶也有一定的影响:变形速率减小,变形温度升高,再结晶体积分数提高;变形速率增大,变形温度降低都导致再结晶晶粒的体积分数减小。进一步的电镜分析表明,GH738合金动态再结晶的形核机制以应变诱发形核为主。The effects of hot working parameters on dynamic recrystallization behaviors of GH738 alloy were investigated by using Gleeble-1500D thermomechanical simulator and microstructure analysis. The results show that the main factor that affects dynamical recrystallization of this alloy is hot reduction rate. With the increasing of this pa rameter, the recrystallization fractions under all tested conditions are increased, inducing the dynamic recrystalli- zation nucleation mechanism for GH738 alloy was strain induced nucleation. During engineering practice, in order to obtain the uniform grain size distribution, the higher deformation temperature and the greater reduction rate （greater than 50% and near 70%） should be adopted.

关 键 词：GH738合金 动态再结晶行为 晶粒分布 

分 类 号：TG111.7[金属学及工艺—物理冶金]