内平动分度凸轮机构受力状态判别方法研究  

Research on force condition of inner parallel indexing cam mechanism

作　　者：刘明涛[1] 陈港[1] 李彦启[1] 郭志全[1] 

机构地区：[1]天津科技大学机械工程学院,天津300222

出　　处：《机械设计》2014年第4期46-49,共4页Journal of Machine Design

基　　金：国家自然科学基金资助项目(50905127);高等学校博士学科点专项科研基金资助项目(20091208120002);天津科技大学引进人才科研启动基金资助项目(20090412)

摘　　要：为准确获得内平动分度凸轮机构的受力状态,以便于对机构传动精度、动力学性能进行研究,文中首先对其分度期同时受力的针齿个数进行分析,然后给出判断实际状态下针齿受力的两个原则,最后得出各针齿在分度期的受力区间。研究结果表明,该机构分度期绝大多数时间同时啮合针齿数大于或等于总针齿数的一半。同时啮合针齿数的波动幅度较大,可能影响机构的动力学性能。尖点修缘量在一定程度上影响了最小啮合针齿数。In order to obtain the force condition of the inner parallel indexing cam ,and process further analysis on the trans- mission accuracy and dynamic performance, the number of forced- pin during indexing period was first discussed. Secondly ,two prin- ciples to confirm the forced pin was shown. Lastly,the interval of each forced pin at the indexing period was given. It is concluded that number of meshing pins is more than half of total pins during most of the indexing period. Variation of the meshing number might have impact on the dynamic performance of the mechanism. The minimum meshing number can be decided by the tooth-tip to some extend.

关 键 词：机械设计 受力状态 多齿啮合 分度凸轮 

分 类 号：TH112.2[机械工程—机械设计及理论]