A303工艺在处理垃圾渗滤液高浓度氨氮废水工程中的应用  

High-Strength Ammonia-Nitrogen Wastewater Treatment Project with A303 Process

作　　者：关国强[1] 徐富[1] 缪恒锋[1] 任洪艳[1] 赵明星[1] 阮文权[1] 

机构地区：[1]江南大学环境与土木工程学院

出　　处：《上海环境科学》2014年第2期69-72,共4页Shanghai Environmental Sciences

基　　金：国家自然科学基金项目(项目编号:20976069);国家科技支撑计划项目(项目编号:2011BAC11B05)资助

摘　　要：将A3O3工艺用于徐州某垃圾焚烧发电厂渗滤液好氧段处理工程，讨论了工艺流程、构筑物设计参数和运行状况。结果表明，在A3O3反应池有机负荷OLR为0．6kg（COD）／（m^3·d）、进水COD为1900～3000mg／L、氨氮为1000～1650mg／L的情况下，出水COD〈800mg／L和氨氮〈5mg／L时，A3O3反应池对COD和氨氮的去除率分别在60％和98％以上。同时分析了pH、DO和温度对氨氮去除率的影响。An introduction was made about the aerobic treatment project with A3O3 process to deal with leachate in a municipal solid waste incineration plant in Xuzhou, and the treatment process, design parameters of structures and commissioning were described. It has shown that when the influent with 1,900 - 3,000 mg/L of COD and 1,000 - 1,650 mg/L of NH3-N was treated by the process, the effluent would be below 800 mg/L of COD and 5 mg/L of NH3-N, i.e., the COD and NH3-N removal efficiencies could be stabilised at 60% and over 98%, respectively, when the organic loading rate （OLR） of A3O3 reactor was 0.6 kg/m3/d of COD. Meanwhile, the influences of pH value, DO, and temperature on ammonia removal were discussed as well.

关 键 词：A3O3工艺 垃圾渗滤液 高浓度氨氮废水 

分 类 号：X703.1[环境科学与工程—环境工程]