检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:张凯[1] 曲大为[1] 马军彦[1] 李君[1] 秦岩[1]
机构地区:[1]吉林大学汽车仿真与控制国家重点实验室,长春130000
出 处:《科学技术与工程》2014年第16期239-243,共5页Science Technology and Engineering
基 金:国家自然科学基金项目(51306070)资助
摘 要:利用AVL FIRE三维商用仿真软件对立体选择性催化还原(solid selective catalytic reduction,SSCR)系统直接喷射NH3时,NH3与尾气在排气道的影响因素进行模拟计算,考察的因素包括工况、NH3温度、喷嘴的安装角度以及喷嘴位置。结论如下:NH3与尾气混合受来流影响较大,排气流量大,排气温度高时,利于NH3与尾气混合;NH3初始温度对于气体混合影响不大;喷嘴安装角度增大利于气体轴向分布,也利于气体混合;SSCR系统直接喷射NH3可以优化喷嘴位置,使排气系统体积减少。The influence factors to the NH3 spray of Solid Selective Catalytic Reduction (SSCR) system was researched by using AVL FIRE 3D commercial simulation software when NH3 and exhaust gas mix in exhaust passage. The influence factors include engine condition, NH3 temperature , nozzle installation angle and nozzle position. The conclusions are as follows:engine condition has much Influence for NH3 and automobile exhaust mixing, the mixing is better, the exhaust flow is larger, the exhaust temperature is high;NH3 initial temperature for the gas mixing has little influence ; nozzle angle increases is good for the axial distribution of gas and the gas mixing characteristics; For the SSCR system direct injecting NH3 can optimize the nozzle position, and reduce the exhaust system volume.
分 类 号:TK421.5[动力工程及工程热物理—动力机械及工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.33