机场登机牌自动盖章控制系统的设计与实现  

Design and Realization of Boarding Pass Automatic Sealing Control System

作　　者：张烈平[1,2] 王春杨[2] 李卫星[3] 黄磊[3] 

机构地区：[1]桂林理工大学广西矿冶与环境科学实验中心,广西桂林541004 [2]桂林理工大学机械与控制工程学院,广西桂林541004 [3]中国民航信息网络股份有限公司广西分公司,广西桂林541001

出　　处：《计算机测量与控制》2014年第6期1809-1811,1814,共4页Computer Measurement &Control

基　　金：广西区自然科学基金项目(桂科自0991252)

摘　　要：针对目前登机牌盖章采用人工验证信息以及人工盖章不能满足实际需求的现状,设计了一种登机牌盖章控制系统;系统由登机牌信息采集、身份证信息采集及登机牌盖章模块3个部分组成;扫描枪自动扫描登机牌条码参数,身份证阅读器采集身份证信息参数,上位机处理核对身份信息,同时采集旅客头像,再通过接口向单片机输出动作信号,单片机向步进电机发出转动参数,步进电机旋转与电磁铁工作,完成信息验证所需的盖章动作;试验结果表明,设计的系统完成信息核对及盖章时间只需要4s左右,系统可靠,盖章效果良好,可以满足机场登机牌自动盖章的实际需求。According to the shortages of manual confirming information and manual sealing, an automatic boarding pass sealing control system based on microcomputer was designed to improve the work efficiency and the confirmation process. The designed system consists of boarding pass information collecting module, ID card information collecting and boarding pass sealing module. The scanning gun gets code pa- rameters from the boarding pass. ID card reader collects ID information parameters, and the computer checks the information and takes pho- tograph at the same time. Computer outputs action signal to chip microcomputer through the USE interface. Chip microcomputer sends a ro- tation parameter to step motor, and the step motor work with the electromagnet to complete the action of stamping for the verification of the information. The experiment results show that the designed system works reliably, and it costs only four seconds to seal well. It can meet the actual demand of airport boarding automatic sealing well.

关 键 词：登机牌 自动盖章 单片机 控制系统 

分 类 号：V446[航空宇航科学与技术—飞行器设计] TP29[自动化与计算机技术—检测技术与自动化装置]