电子式互感器相位补偿方法的研究和比较  

Research and Comparison on Phase Compensation Schemes for Electronic Transformer

作　　者：朱鹏[1] 李开成[1] 孙健 何昊[1] 

机构地区：[1]华中科技大学强电磁工程与新技术国家重点实验室,武汉430074 [2]江苏省电力公司电力科学研究院,南京211102

出　　处：《电测与仪表》2014年第12期7-11,28,共6页Electrical Measurement & Instrumentation

基　　金：国家自然科学基金资助项目(51077058;51277080);江苏省电力公司科技项目(J2012035)

摘　　要：电子式互感器的相位误差是影响互感器测量精度的重要因素,可以采用相位补偿方法对其加以校正。文章给出了电子式互感器的设计原理,分析了电子式互感器相位误差产生的原因,介绍了全通滤波器、短数据窗移相算法、傅里叶移相算法等相位补偿方法,研究了谐波对上述补偿方法的影响,在此基础上提出了改进的相位补偿方法:移点法和线性相位全通滤波法,并进行了实验测试。实验结果表明,互感器的角差满足0.2级测量精度要求,改进的相位补偿方法具有可行性。The phase error of electronic transformer is an important factor which will affect the measurementaccuracy. However, the phase error can be modified through a proper phase compensation scheme. The principle ofthe electronic transformer has been given out and the causes of phase error have been analyzed. The phasecompensation schemes, including all-pass filter, phase-shifted algorithm of short data window, and phase-shiftedalgorithm of Fourier, have been introduced. The influence of the harmonic on above schemes has also beenresearched. On this basis, an improved schemes of phase compensation is presented, , namely sampling pointsremoved and the linear phase of all-pass filter scheme. The experimental results show that the phase error oftransformer can meet the class 0.2 accuracy requirements so as to verify the feasibility.

关 键 词：电子式互感器 相位误差 测量精度 相位补偿 谐波 

分 类 号：TM45[电气工程—电器]