电参数对钛合金放电诱导可控烧蚀车削加工的影响研究  

The Influence of Electrical Parameters on Controllable Spark-induced Combustion Turning on Titanium Alloy

作　　者：尹纯晶[1] 刘志东[1] 凌加健[1] 邱明波[1] 田宗军[1] 

机构地区：[1]南京航空航天大学机电学院,江苏南京210016

出　　处：《电加工与模具》2014年第3期43-47,共5页Electromachining & Mould

基　　金：国家自然科学基金资助项目(51175256;51205197);航空基金资助项目(2011ZE52060);江苏省自然科学基金资助项目(BK2011732)

摘　　要：设计了基于放电概率的诱导烧蚀电极伺服控制系统,通过优化实验,设定其放电概率为80%,并在此基础上分析了脉冲宽度、脉冲间隔、峰值电流等电参数对加工的影响。结果表明:正极性加工时,峰值电流对加工效率的影响最大。通过选取优化参数,与常规电火花车削对比表明:放电诱导可控烧蚀车削的材料加工效率是常规电火花车削的27倍,电极相对损耗仅为常规电火花车削的80%。A servo control system for inducing combustion electrode based on discharge probability which is setted to 80 % through the optimization experiment,is designed. Then the machining influence of electrical parameters including pulse width,pulse interval and peak current,is analyzied. The result shows that the peak current has the greatest impact on machining efficiency under the condition of positive polarity machining. Then the controllable spark-induced combustion turning is compared with conventional EDM turning by the optimization parameter selection. The results show that the material machining efficiency increases 27 times than conventional EDM turning and the electrode relative loss is reduced 80 % compared with conventional EDM turning

关 键 词：电参数 放电诱导 可控烧蚀 放电概率 加工效率 

分 类 号：TG661[金属学及工艺—金属切削加工及机床]