移动床内高炉渣热载体与生物质热解液化实验研究  

Research on bio-oil production by biomass pyrolysis using blast furnace slag as heat resource in moving bed reactor

作　　者：周扬民[1] 罗思义[1] 李宗刚[1] 岳霞[1] 王亭亭[1] 仪垂杰[1] 于进江 

机构地区：[1]青岛理工大学,山东青岛266033 [2]青岛钢铁有限公司,山东青岛266033

出　　处：《热科学与技术》2014年第2期165-168,共4页Journal of Thermal Science and Technology

基　　金：青岛市科技计划资助项目(13-1-4-175-jch;KJZD-12-55-jch)

摘　　要：以移动床为高炉渣余热裂解生物质实验平台，研究高炉渣温度、粒径和生物质粒径等对生物质热解产物分布的影响。结果表明，生物油产率随着高炉渣温度的增加先增加后减小，当高炉渣热载体温度为650℃时，生物油产率最高；高炉渣粒径和生物质粒径越小，生物油的产率越大。炉渣温度650℃、粒径0～2mm，生物质粒径小于75μm，生物质油产率达到57．3％。生物油中含氧量和含水率较高，热值低，pH值为3．7。Bio-oil production by pyrolysis of biomass using waste heat from hot BF slag were conducted in moving bed reactor. The influences of BF slag temperature and particle size of biomass and BF slag particles on pyrolysis charaeteristics of hiomass were discussed. The results show that in order to achieve a high bio-oil yield, moderate temperature, smaller BF slag particles and biomass particles are required. At temperature of 650 ℃, BF slag with particle sizes below 2 mm and biomass particle sizes below 0.075 mm were used as test samples, the maximum bio-oil yield reached 57.3%. The oxygen and water content in the bio-oil were high, while the calorific value was low and its pH value was 3.7.

关 键 词：高炉渣 生物质 移动床 生物油 

分 类 号：TK6[动力工程及工程热物理—生物能]