分步加压法测量薄壁空心玻璃微球的耐压能力  

Method to measure the failure pressures of hollow glass microspheres with high aspect ratios

作　　者：邱龙会[1] 傅依备[1] 唐永建[1] 郑永铭[1] 师滔[1] 袁玉萍[1] 

机构地区：[1]中国工程物理研究院激光聚变研究中心,四川绵阳621900

出　　处：《强激光与粒子束》2001年第5期591-594,共4页High Power Laser and Particle Beams

基　　金：国防预研基金资助课题 (5 4.9.4);中国工程物理研究院科学基金 (990 5 5 3 )资助课题

摘　　要：根据空心玻璃微球 (HGM)耐内、外压能力与玻璃强度及形状因子的关系 ,用分步加压法测量了直径为 3 5 0～ 5 5 0μm,壁厚小于 1 .1μm的 3种配方 HGM的耐内、外压能力及 HGM玻璃的杨氏模量和拉伸强度 ,并由强度测定值给出了不同直径与壁厚 HGM的耐内、外压能力的计算式 ,分析了测量误差 。An experimental method, pressure loading by steps, was designed to measure the fracture and buckling failure pressures of hollow glass microspheres(HGM) for use in laser fusion experiments. The failure pressures of 3 kinds of HGM with out diameters of 350-550μm and wall thickness less than 1.1μm and the HGM glass's elastic moduli and tensile strengthes were measured experimentally. From these results, experimental formulae were obtained to evaluate the failure pressures of HGM in different out diameter and wall thickness without any test. Moreover, the experimental error sources and ways to improve them are discussed.

关 键 词：激光聚变靶丸 空心玻璃微球 分步加压法 耐压能力 测量 杨氏模量 

分 类 号：TL632.1[核科学技术—核技术及应用] TQ171.12[化学工程—玻璃工业]