基体钢制冷作模具表面强化研究  

Study on Surface Hardening of Cold-forging Dies Made of Matrix Steel

作　　者：胡学军[1] 邓鸣[1] 朱福如[1] 陆德平[1] 许兰萍[1] 林凌云[1] 

机构地区：[1]江西省科学院,南昌330029

出　　处：《金属热处理》2001年第8期27-28,共2页Heat Treatment of Metals

基　　金：江西省重点科技项目

摘　　要：研究了基体钢 7Cr4MoSiV1的力学性能和其离子氮碳共渗和气相沉积TiN工艺。结果表明 ,该钢具有较高的强韧性、良好的渗氮和镀膜性能。其屈服强度σ0 2 为 2 2 0 0～ 310 0MPa ,抗弯强度为 35 0 0～ 5 0 0 0MPa ,冲击韧度为 2 0～ 70J/cm2 。离子氮碳共渗层深度为 0 1～ 0 3mm ,表面硬度为 10 0 0～ 130 0HV0 0 2 5 ;多弧离子镀TiN膜与基体结合较好 ,表面硬度为 15 0 0～2 0 0 0HV0 0 2 5。用 7Cr4MoSiV1钢并经表面强化的冷作模具使用寿命比原模具提高 1～The mechanical properties of matrix steel 7CrMo4SiV1 and its plasma nitrocarburizing and TiN deposition properties have been studied.The results showed that 7Cr4Mo4SiV1 steel has a high strength and toughness and good nitrocarburizing and TiN deposition properties.Its compressive yield strength (σ 0 2 ) is 2200～3100MPa,bending strength (σ bb ) is 3500～5000MPa,impact value is 20～70J/cm 2.The plasma nitrocarburized case depth is 0 1～0 3mm,its hardness is 1000～1300HV0 025.The TiN layer deposited by multi arc plasma combines closely with matrix and the hardness is 1500～2000HV0 025.The Service life of cold forging dies made of matrix steel 7Cr4Mo4SiV1 through surface hardening is 1～10 times longer than these of the original ones.

关 键 词：冷作模具 表面强化 基体钢 离子镀 离子碳氮共渗 

分 类 号：TG162.4[金属学及工艺—热处理] TG174.444[金属学及工艺—金属学]