检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:肖大志[1] 何高法[1] 雷亚[1] 王春涛[1] 刘静安
机构地区:[1]重庆工业高等专科学校,重庆400050 [2]西南铝业集团有限责任公司,重庆401326
出 处:《金属成形工艺》2001年第6期17-19,共3页Metal Forming Technology
基 金:重庆市科委资助项目
摘 要:通过对扁挤压筒结构的优化分析 ,提出了局部预压力结构扁挤压筒模型 ,给出了对模型的有限元分析结果。采用局部预压力结构方法设计的扁挤压筒 ,与等效厚壁圆筒法设计的扁挤压筒相比 ,在同等条件下 。Based on analysis of optimization in the structure of flat extruded cylinder, the model of flat extruded cylinder with local prepressed structure is designed and the results of finite element analysis of the model have been provided. Compared with flat extruded cylinder by means of equivalent thick cylinder, the flat extruded cylinder by means of local prepressure can make the equivalent stress on the dangerous part reduced by 30 percent under the equivalent condition.
分 类 号:TG375.43[金属学及工艺—金属压力加工]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.229