热处理对1.6C-10Cr模具钢组织与性能的影响  

The Effeet of Heat Treatment on Microstructures and Properties of Die Steel 1.6C-10Cr

作　　者：潘祖诒 石荣才 冷光荣 陈海平[2] 肖洪斌[2] 王进辉 程小三 

机构地区：[1]江西省钢铁研究所,江西新余338013 [2]新余钢铁有限责任公司,江西新余338013

出　　处：《金属热处理》2002年第1期5-8,共4页Heat Treatment of Metals

基　　金：江西省工业重点科技计划项目 (1 999 2 8)

摘　　要：通过力学性能测试和金相组织观察 ,分析了热处理对试验钢组织与性能的影响 ,提出了优化的热处理工艺 :试验钢经 85 0～ 870℃退火 ,硬度≤ 2 30HB ;经 95 0～ 10 0 0℃淬火 ,硬度达到 6 2～ 6 4HRC ,晶粒度等级为 7～ 9级 ;经 970℃淬火 +2 0 0～ 30 0℃回火 ,硬度≥ 6 0HRC ,冲击韧度达到 10～ 12J/cm2 。冲裁 0 5mm厚热轧硅钢板的试验钢模具寿命达到 6 0万件以上。Through studying the mechanical properties and microstructures the effect of heat treatment on microstructures and properties of 1 6C 10Cr steel was analyzed and the optimum heat treatment was pointed out:the hardness of the steel annealed at 850～870℃ is less than 230HB.The hardness of the steel quenched from 950～1000℃ is 62～64HRC and the grain size grade is 7～9.The hardness of the steel quenched from 970℃ and tempered at 200～300℃ is more than 60HRC,the impact toughuess is 10～12J/cm 2.The service life of the steel die punching the 0 5mm thick hot rolling silicon steel sheets can reach more than 6×10 5 times.

关 键 词：热处理 组织 性能 模具钢 

分 类 号：TG142.45[一般工业技术—材料科学与工程] TG161[金属学及工艺—金属材料]